KYOWA KW-1503 User manual

KYOWA SERVICE CENTER
Rm. 1203 State Center Building
#333 Juan Luna St., Binondo
Manila, Philippines
HOT AND NORMAL
WATER DISPENSER
MODEL NO: KW-1503
Voltage: 230V a.c. 60Hz Power: 500 WATTS
INSTRUCTION MANUAL

IMPORTANT SAFEGUARDS
When using the Water Dispenser, basic safety precautions should always be
followed:
Always operate your KYOWA Water Dispenser from a power source of the
same voltage and frequency rating as indicated on the rating label.
Connect the Water Dispenser unit only to properly wired wall outlets.
Do not use Water Dispenser in damp or wet area. Keep dry the motor and
the base of the unit.
Do not operate or place any part of your KYOWA Water Dispenser on or
near any hot surface such as a gas or electric burner, hotplate or heated
oven.
Place the Water Dispenser on a flat area surface. Never turn the unit
upside down.
Keep at least 15 cm. of space between the wall and the Water Dispenser
for proper ventilation.
This unit is most suitable for 3 to 5-gallon bottle of water.
Do not plug in Water Dispenser or put the Heating switch to ON until the
water runs out from the hot water tap.
Do not operate the Water Dispenser if any part of it has been damaged.
Return the appliance to the nearest authorized dealer or service facility
for repair.
Do not use or replace accessories other than the ones originally provided.
Hold plug when unplugging from socket. Do not unplug by pulling the
supply cord.
To reduce the risk of electric shock, do not immerse or expose the Water
Dispenser to rain, moisture or any liquid.
If this unit is not intended to be used for a long time, turn Water
Dispenser to OFF, unplug socket from the power supply and drain
remaining water in the container.
Keep out of reach from children or from persons with mental or physical
disabilities.
This KYOWA Water Dispenser is intended for normal domestic/household
use only. This unit is not suitable for commercial use.
CONGRATULATIONS
You are now a proud new owner of a KYOWA Water Dispenser model
no. KW-1503.
Before using for the first time, kindly take time to carefully read your
instruction manual. Please observe all safety precautions and follow
operating procedures. After reading, kindly store your instruction manual in
a safe place for your future reference. Should you pass on this Water
Dispenser to a third party, please hand over this instruction manual as well.
PARTS DESCRIPTION
1
2

HOW TO USE
Remove all packaging materials from the Water Dispenser. Completely
untangle or unwind the power cable of the unit.
Before initial use, the Water Dispenser must be plugged into a wall
receptacle that is properly installed and grounded to reduce risk of
electric shock.
Tear the label or any sealing material on the cover of the bottle.
Vertically insert the bottle supporter on top of the machine. Do not plug
in cord or turn the unit ON until water runs out from the hot water tap.
Allow about 1 liter of water to run out from the dispenser when using for
the first time.
TROUBLE SHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Water coming out
from the hot
dispenser is
lukewarm.
1. Water from the hot
container has
already been
consumed.
2. . No power supply.
1. Wait for about three
minutes to allow heating
of water from the unit.
2. Check if the power cord is
properly plugged into the
power supply.
No water coming out
from the dispenser
1. The water bottle is
empty.
2. Inlet of bottle
supporter is blocked.
1. Replace with another
bottle of water.
2. Remove object that was
blocking the water flow.
Water leaks coming
out from the bottle
supporter
The water bottle is
broken.
Replace with a new bottle of
water.
Too much noise
when dispensing
water from the unit
Water Dispenser is
tilted or not installed
properly.
Place unit upon a flat area
and stable surface.
CLEAN AND CARE
Wash Bottle Supporter and Water Tank regularly to maintain optimum
performance of the Water Dispenser.
Do not use harsh cleaning agents or abrasive objects (e.g. scrubbing pads
or metal brushes) for cleaning.
Put back parts and accessories of the Water Dispenser to their proper
places before operating again.
Wipe dry all parts of the Water Dispenser using a soft and dry cloth.
SERVICE
Do not operate your KYOWA Water Dispenser if the unit malfunctions or
appears damaged in any manner. Bring the complete product to the place
of purchase or to any authorized KYOWA dealers for inspection, repair or
replacement.
Do not disassemble your KYOWA Water Dispenser by yourself. No user
serviceable parts inside. Refer all needed repair to an authorized KYOWA
service facility ONLY.
3
4