La Marzocco linea mini User manual

connected linea miniretrofit kit.

safety first!
BEFORE TO START, PLEASE MAKE SURE YOUR MACHINE IS DISCONNECTED FROM THE ELECTRICAL SUPPLY.

remove the cup tray and electronic box.

We recommend marking each wire before to remove it.
disconnect all connectors from the board.
ATTENTION:
All high voltage wires are connected to the board with
the green quick connector which is shown in the picture.
This connector has a drop of glue to prevent from
accidentaly disconnecting and may result difficult to
separate.
Should you find it too hard to pull out, we suggest to
remove each wire individually by untightening the flat
head screw which is indicated with the orange arrow.
A new connector is provided in the kit for replacing if
necessary.

board re-wiring.
old electronic board. new electronic boards.
(picture of the 220V version)
ATTENTION:
MAKE SURE THE SELECTORS
ARE POSITIONED AS SHOWN
110V
220V

place the new electronic box in the machine.

locate the QR-code on the electronic box.
You should have found two QR-codes with the kit.
Stick one of them on the electronic box and stick
the other one in the inside of the black frame
(alongside the water tank).
Contact us to get the APP TECH if you don’t have it
yet.
Open the app and point the QR-code with your
smartphone camera. Now follow the instructions to
activate online your kit, paying attention to insert
the correct serial number of the machine as
required.
Now you can reassemble the machine and plug it.
Follow the app’s instructions step by step to
complete the set up.