Langria 177886201 User manual
5-TIER WIRE SHELVING UNIT
Assembly Instructions
PARTS LIST
EN-1
Please check and make sure that you have all the parts ready before beginning
assembly
54
4
48/2(Spare)
4
L
Parts
Photo
Qty
Parts
Photo
Qty
Parts
Qty
4
Shelf Top Post
Middle Post Down Post
Clip Leveling Foot
This disk is just for protecting component parts from damage during shipping and can be
discarded after assembly.
EN-2
ASSEMBLY STEPS
Screw the leveling feet into the bottom of down posts.
Step1
Down Posts
D
F
Leveling Foot
EN-3
Step 2
Count the grooves in the posts to make sure the
clips are level.
Snap clips (for the bottom tier) at the desired height onto the down posts.
Make sure rib on clip fits into a groove on
the post.
Down Posts
D
Down Posts
D
E
Rib
Groove
Arrow
Up
Clip
EN-4
Step 3
Shelf
Top
Down
Up
Slide a shelf down the bottom posts through the tapered openings in its corners
until it is resting on the clips.
The wider end of the tapered opening
should go toward the bottom.
A
EN-5
Step 4
Shelf
Adjust the leveling feet if placed on an uneven ground.
Leveling Foot
Tap the shelf (with a mallet on a cloth) in the corners to make sure it is snug over
the clips.
A
F
EN-6
Step 5
Install the middle posts and then the top posts.
Middle Post
Down Post
Insert
C
D
B
B
B
B
C
C
C
C
A
Top Post
Insert
B
EN-7
Step 6
A
Insert the remaining shelves.Refer to Steps 2 & 3 & 4, working from bottom to top.
A
A
A
A
Other manuals for 177886201
1
Table of contents
Other Langria Rack & Stand manuals
