Langria 3-TIER WIRE BAKER'S RACK User manual

Assembly Instructions
3-TIER WIRE BAKER’S RACK

PARTS LIST
Shelf with Railing Below* Shelf with Railing Above*
Front Top Post Back Middle Post Back Top Post
Down Post Hook Rail Board
Small Shelf *
11
EN-1
2
1
2
4 1
2
4
30 / 2 Spare
2
L
Parts
Photo
Qty
Parts
Photo
Qty
Parts
Photo
Qty
Parts
Photo
Qty
Clip Leveling Foot
HI
J K
* The side that faces upward should be the side where corner openings taper from bottom to top.
G
Please check and make sure that you have all the parts ready before begin-
ning assembly
These discs are placed between the stacked shelves in the shipping box - they are
for protection only and can be discarded after assembly.

EN-2
ASSEMBLY STEPS
Screw the leveling feet into the bottom of down posts.
Down Post
G
K
Leveling Foot
Step1

EN-3
Count the grooves in the posts to make sure
the clips are at the same height.
Snap clips (for the bottom tier) at the desired height onto the down posts.
Make sure rib on the clip is fitted into a
groove on the post.
Down Post
G
Down Post
G
J
Rib
Groove
Arrow
Up
Clip
Step 2

EN-4
Slide B down the bottom posts through the tapered openings in its corners until it is
resting on the clips.
The wider end of the tapered opening
should go toward the bottom.
Shelf
B
Top
Down
Up
Step 3

EN-5
Tap the shelf in the corners (covered with a cloth and use a mallet) to make sure
it is snug over the clips.
Shelf
B
Adjust the leveling feet if placed on an uneven ground.
K
Leveling Foot
Step 4

Install B. Refer to Steps 2 & 3 & 4.
B
Step 5
EN-6

EN-7
Install the front top post and back middle post and then the back top post.
G
G
Step 6

Install A. Refer to Steps 2 & 3 & 4.
A
EN-8
Step 7

EN-9
I
C
H
Install the hook rail and then the small shelf. Refer to Steps 2 & 3 & 4.
Place the board on the first tier of the unit.
Step 8

www.langria.com
E-mail: [email protected]