Lanpro LP-F22 Series Installation guide

Fiber Solutions - Rack Mounted Optical Distribution Frames (ODF)
123 Manual, LP-F22XXYYYBK Horizontal Fiber Optical Splice Closure.
Assembling Instructions
LF22XXYYYBK_M123_ENB01W
www.lanpro.com
123 Manual, LP-F22XXYYYBK
Horizontal Fiber Optical Splice Closure.
Assembling Instructions.
This 123 Manual will guide you step by step in the process
of assembling Horizontal Fiber Optical Splice Closure
LP-F22XXYYYBK by LanPro.

www.lanpro.com
Fiber Solutions - Rack Mounted Optical Distribution Frames (ODF) - 123 Manual, LP-F22XXYYYBK
Horizontal Fiber Optical Splice Closure. Assembling Instructions
2
First prepare closure and accessories, as shown in
Figure 1.
Strip optical cable, as shown in Figure 3.
Fix the optical ber to splice case, coil the rest of the optical ber inside splice case base, and Fix the optical ber to
down body as shown, Figures 5a and 5b.
Prepare Installation Tools, as follows, Figure 2.
Tighten the cable on the holder by cross screwdriver, as
you can see in Figure 4 bellow.
1
3
5
2
4
Figure 1
Figure 3
Figure 5a Figure 5b
Figure 2
Figure 4

www.lanpro.com
Fiber Solutions - Rack Mounted Optical Distribution Frames (ODF) - 123 Manual, LP-F22XXYYYBK
Horizontal Fiber Optical Splice Closure. Assembling Instructions
3
Fix the weld ber optics to the in-and-out port of the ber splice and Put splice tray cover on. As shown in Figures 6a
and 6b.
Seal the unused ports by plugs, as shown in Figure 7. Close the up shell. Tighten shells by bolts. Figure 8.
6
7 8
Figure 6a
Figure 7 Figure 8
Figure 6b
LanPro is continuously improving its products and reserves the right to change specications and availability without prior notice.