Launch CReader CR7001 User manual

Register& Update for CR7001, 7001F, 8001, 8011, 8021, 9081
Take CR8011 for example:
Follow the steps described as below to perform the registration and
update:
1. Go to the launch website: mycar.x431.com and click Products >
CR8011.
2. Download and install the Update Tools and launch the program when
installed. You will be prompted to type in the Serial Number(located at
the back of the device)

3. After the S/N is entered, click Device Upgrade and enter the following
information (e-mail address and register code), click Submit.
a) The Register Code can be found when you connect the device to your
computer via USB cable.
b) When the device has powered up, place the cursor on the Help > Tool
information.

4. Please take the TF card out to the card reader and insert into the
computer.
5. Reopen the CR update suite; fill in your user password, click OK.(Note:
User password is the Register Code)
6. Select the updates you’d like to perform or click Select ALL and click
Download. (Caution: Do not disconnect USB while downloading.)

6. Once the updates are finished, it will pop up the following bar and
click OK.
6. Once all steps are completed, please repower up the device via USB in
computer. Then click OK to start updating. It may take a while to finish
the update. The device will display as below:

7. Now the registration and upgrading process is completed and you can
enjoy the updated software.
Note: Please make sure the card reader is removed safely.