YORK DECK MOUNTED BATH SHOWER MIXER
INSTALLATION & AFTERCARE INSTRUCTIONS
INSTALLATION PROCEDURE
1) Prior to installation flush out the pipe work to remove debris and then ensure the water supply is
turned off.
2) Refer to diagram and ensure all components are present.
3) Fit the bath filler to the bath ensuring the rubber washer and fixing nut are on the underside of the
bath.
4) Connect to the water supply ideally applying PFTE tape on the threads to form a watertight seal.
The hot water supply should always be connected to the left hand leg.
5) Fully open both valves and allow to run for approximately 1 minute to fully flush the system.
6) Check all connections for leaks.
7) Attach the end of the shower hose with the large nut shaped fitting to the bottom of the diverter
valve. The other end should be attached to the shower head (see diagram).
8) Establish the desired position for the shower head wall-mounting bracket. Check that the bracket is
oriented correctly & that the shower head will reach by placing it temporarily in position. Caution:
Before drilling, check for hidden power cables and pipes. Take care using power tools, especially near
water. The use of a residual current device (RCD) is recommended.
9) Drill a single 8mm hole in the desired position for the shower head mounting bracket and insert the
supplied nylon plug into the hole.
10) Disassemble the wall mounting bracket by unscrewing the cover cap from the cover plate and insert
the supplied screw through the centre of the cover plate and screw into the wall, making sure the
O-ring is placed between the wall and cover plate. Re-assemble the bracket in the order shown and
place the shower head in position.
Fixing Nut
Rubber Washer
Arm
Cover cap
Spring plate
Spring
Screw
Cover plate
O-ring
Shower head
Diverter valve
(Clockwise - shower,
Anti-clockwise - spout)
