LCI Screen Defender User manual

Screen Defender
OEM INSTALLATION MANUAL

Rev: 10.25.19 Page 2 CCD-0003381
TABLE OF CONTENTS
Introduction 2
Safety 2
Installation 3
Introduction
The Screen Defender is a metal mesh insert that will be attached to the interior of an RV entry screen door to
prevent accidental damage to the screen.
For information on the assembly or individual components of this product, please visit:
https://support.lci1.com/entry-doors .
NOTE: Images used in this document are for reference only when assembling, installing and/or operating
this product. Actual appearance of provided and/or purchased parts and assemblies may differ.
Safety
Read and understand all instructions before installing or operating this product. Adhere to all safety labels.
This manual provides general instructions. Many variables can change the circumstances of the instructions,
i.e., the degree of difficulty, operation and ability of the individual performing the instructions. This
manual cannot begin to plot out instructions for every possibility, but provides the general instructions,
as necessary, for effectively interfacing with the device, product or system. Failure to correctly follow the
provided instructions may result in death, serious personal injury, severe product and/or property damage.
Moving parts can pinch, crush or cut. Keep clear and use caution.
The “CAUTION” symbol above is a sign that a safety risk is involved and may cause personal injury
and/or product or property damage if not safely adhered to and within the parameters set forth
in this manual.

Rev: 10.25.19 Page 3 CCD-0003381
Installation
1. Completely open the RV entry and screen doors and place them flush against the unit.
2. Tilt the Screen Defender and direct one side of the Screen Defender toward the back window channel
of the screen door (Fig. 1).
3. Insert the channel guide at the bottom of the Screen Defender into the back window channel of the
screen door.
4. Insert the channel guide on the other side of Screen Defender into the back channel of the screen door
and push down on the Screen Defender until it is seated in the screen door channel.
5. Squeeze the retractable latches on the top of the Screen Defender (Fig. 1) and push the Screen
Defender into the back of the screen door.
6. Release the Screen Defender latches.
7. The Screen Defender is installed (Fig. 2).
Fig. 1
Fig. 2
Channel Guide
Back Channel
Retractable Latch

The contents of this manual are proprietary and copyright protected by Lippert Components, Inc. (LCI).
LCI prohibits the copying or dissemination of portions of this manual unless prior written consent from an
authorized LCI representative has been provided. Any unauthorized use shall void any applicable warranty.
The information contained in this manual is subject to change without notice and at the sole discretion of LCI.
Revised editions are available for free download from lci1.com.
Please recycle all obsolete materials.
For all concerns or questions, please contact
Lippert Components, Inc.
Ph: [phone] | Web: lci1.com | Email: [email protected]