Leafield Environmental Litter Bin Instruction sheet

Cleaning
water and then washed with a mild detergent
solution using a bristle brush or sponge. Care should
be taken not to apply undue pressure that may
damage labels. Flush clean with water after washing.
Manufacturing Standard (as applicable)
All LEAFIELD Environmental products are
manufactured to BS EN ISO 9002.
Plastic materials: Mechanical properties tested to
BS 2782 Hot dipped galvanized: BS 729
Powder coating: BS 3900 Zinc coating: BS 1706
Tools Chalk, hammer drill, 12mm masonry
drill bit, mallet, 17mm socket,
Key:
PPE Always wear appropriate PPE equipment and
follow safety guidelines
Installation guidelines
LEAFIELD litter bins
Round Heritage
Position the ballasting base so that the locking
pin faces the direction that the lock on the bin
will face
Using chalk, mark the position through the
three holes onto the ground bellow
Remove ballast cartridge and clearly mark the
ground in the three hole positions with a cross
12 3
Preparation
ballasting
additional components:
Available as optional
extra.
Gravel for ballasting
should be supplied by
the contractor
Washer Ballast bung
X3X3 X1
cartridge)
100mm

Drill 12mm holes in the three marked positions
to a depth of 100mm to accommodate the
bolt length, remove debris from holes
Re-position the base over the drilled holes. Add
washers to bolts and push through moulded
holes in base locating into drilled ground holes
Using a mallet drive the bolts home
Use a spanner or socket to tighten the bolts
Tighten the bolts to 22.0Nm torque for
concrete. Tightening the bolts will fan out the
bolt sheath in the hole holding the bolt secure
Remove cap from integral ballasting base and
pour gravel into the center
Disperse the gravel equally across the bottom
of the raised level indicator
Replace liner and hood. With hood resting on
base rotate hood clockwise until it will rotate
no further. Push lock in to engage
Replace liner and hood. With hood resting on
base rotate hood clockwise until it will rotate
no further. Push lock in to engage
4 5 6
7 8 9
21 3
Drilling holes and inserting bolts
Filling integral ballast
Tightening bolts
telephone
+ 44 (0)1225 816500
enter
fax number
facsimile
+ 44 (0)1225 816501
post
Corsham, Wiltshire SN13 9UD
website/email
www.leaeld-environmental.com
envinfo@leaeld.com