LeakAlertor 6000 User manual

LeakAlertor®6000 User’s Guide
www.leakalertor.com
tel: [phone] |toll free: 877.532.5253
LA6KUG DEC16 15 E. Uwchlan Ave Ste 412 | Exton, PA 19341
Installing Your LeakAlertor –This is SO easy!
1) Remove tank lid.
2) Place the LeakAlertor
over the edge of the tank.
3) Replace tank lid.
4) Pull battery tab.
5) That’s It!! You’re Done!
I Just Pulled the Battery Tab…Now What Happens? Relax…
The LeakAlertor needs about an hour to get to know your toilet. During that time, you’ll see the
GREEN LED “triple flash”. Don’t worry -you can still use the toilet. Once the LeakAlertor feels
at home, all three LEDs will begin to flash at once. Just flush the toilet and the LeakAlertor will
go to work.
How do I know if I have a problem with my toilet?
Every time you flush the toilet, watch the LeakAlertor!
What to expect when the toilet is Flushed:

LeakAlertor®6000 User’s Guide
www.leakalertor.com
tel: [phone] |toll free: 877.532.5253
LA6KUG DEC16 15 E. Uwchlan Ave Ste 412 | Exton, PA 19341
Testing the LeakAlertor -Easy as 1-2-3
1)Press and Hold the RESET button until the RED, and
then the YELLOW LED flashes.
2)Release the RESET button.
3)Watch the LED colors while the toilet flushes*:
a) RED LED - as the water goes down,
b) GREEN LED - as the water fills up,
c) YELLOW LED - when the water isn’t going up or
down.
The unit exits TEST mode automatically after about three minutes.
The unit flashes the YELLOW LED during TEST mode when the
toilet is not actually flushing. Do not test the unit for at least two
to three minutes after you last flushed the toilet.
*(Note: When the water has reached its lowest level in the tank during the flush, the water
turbulence may cause the unit to appears as though the LEDs are flashing randomly for a
few seconds. The unit is detecting the rising/falling water height of the turbulence and
alerting accordingly. Once the water height begins to steadily rise, the unit will contine to
flash the green LED until the water height stabilizes at the end of the flush.)
Re-Setting the LeakAlertor
1) Press and Hold the RESET button until the RED LED flashes,
then release it.
2) The unit flashes all three LEDs and beeps. The unit flashes
just the GREEN LED for about a minute then will flash all three
LEDS at the same time.
3) Flush the toilet any time after all three LEDS are flashing to
complete the reset.
You’re all done, the unit has been reset!!
Reset the LeakAlertor to:
Make a repair to the toilet,
Temporarily silence the alerts,
Remove the unit temporarily from the toilet.