LED's light 1000447 User manual

Instruction Manual
The light turns on automatically in darkness and will turn off once exposed to sunlight again.
The runtime of the light is dependent on the amount of charging time that the solar panel is exposed to:
a)The longer of the exposure of sunlight, the better the performance of the solar light.
b)For best results, place the light panel where there is ample sunlight exposure to charge your light.
c)Maximum sunlight exposure will allow the light to work for up 8 hours.
If use of the solar light is not required for a long period of time, it is recommended to switch the product to
“OFF” to preserve the battery.
We recommend to shelter this product during long winter periods (snow, rain) in order to preserve the product.
This product is rainproof, but may leak and fail if fully submerged in water. The spike should be pushed into
the ground, but leave the lamp body above ground.
Do not locate the light in an area where it may become submerged in water when it rains. E.g. where puddles
form.
X1
X3
X2
X3
X1
X1

48h
To ensure proper product operation, the batteries must
first be fully charged for two days MINIMUM. To do
this, the product has to be turned on the first two days.
Do not touch the top of the solar light with any hard
material as this could break, scratch or damage the
solar panel.
IP44
Replacing the Battery
To replace the rechargeable battery please follow
these steps:
a) Use a screwdriver to remove the screws on the battery cover.
b) Install new rechargeable batteries.
c) When resealing, ensure that all screws are replaced and secured tightly.
(Battery specification:1.2V Ni-MH rechargeable battery).
Remark:
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon zinc), or rechargeable (ni-cad, ni-mh, etc.) batteries.