LEDGE SIGNATURE CHAISE User manual

IMPORTANT NOTE
No tools required for assembly.
ASSEMBLY GUIDE FOR
SIGNATURE CHAISE
& CHAIR SHADE
STEP 1: Set one side frame piece down with holes
facing up.
STEP 2: Match holes of the frame piece with tabs of
the middle crossbars, inserting the 3 middle crossbar
pieces into the side frame piece, and apply pressure
to lock them together.
Nub
Groove Step
STEP 3: Set the second frame piece on top, repeating
the process of inserting the tabs into the holes, and
apply pressure to lock them together.
STEP 4: Slip fabric on to the frame with the clear
media viewing window facing the inside of the curve,
or the bottom of the shade. Close velcro flap.
media viewing
window

SHARE YOUR MEANINGFUL MOMENTS WITH US
STEP 5: Slide frame on to the back of seat. In some
cases there’s a gap between the seat and shade, this is
normal as long as shade feels secure.
STEP 6: You’re all done, enjoy your new product
and begin creating life’s most meaningful moments.
ROUTINE CLEANING
For routine cleaning, just use water and a soft cloth
or microfiber towel, or spray down with a water hose.
For a deeper clean, use mild soap and water and a soft
bristle brush.
POWER WASHING
If power washing is desired, start with a low PSI,
at least 3 ft away from furniture. Move closer or increase
PSI gradually and with caution. While power washing,
check often to ensure no inscription is left on the surface.
For more information on cleaning & care, please visit
ledgeloungers.com/faq
Gap