LEDGE PING PONG TABLE User manual

BEFORE YOU START
Unpack and lay all Ping Pong Table pieces
flat on a padded surface to avoid scratching
or damaging the components.
Look for an engraved letter near each slot on
the enclosed riser pieces. Always match up
coordinating slots (A+A, B+B, etc.) to ensure
proper assembly.
Locate and count all hardware before
discarding any packaging.
REQUIRED TOOLS
IMPORTANT NOTE
The Ping Pong Table is designed for
on-deck use only.
STEP 1: Align the corresponding slots of the bottom
crossbars and the table legs. Make sure the letter
system is facing the inside of the table. Slide the
pieces together, using a mallet if needed. Continue
until all four pieces are assembled together.
PING PONG TABLE
STEP 2: Align the corresponding letters of the shelves
and drop them on the L-slot tabs. Slide inward until it
locks into place, using a mallet if needed.
(20) KEYS (22) SCREWS
ALLEN WRENCH
A
B
E
F
I
JK
L
E
F
A
B
I
JK
L
C

STEP 3: Align the corresponding letters of the two
brackets and insert them into the table legs. Slide the
pieces together, using a mallet if needed.
STEP 4: Align the corresponding letters of the
top crossbars and insert them into the table legs.
Slide the pieces together, using a mallet if needed.
Continue until you have inserted all four crossbars
(two middle crossbars, two end crossbars) into the
table legs and the tops are flush.
STEP 5: Align the corresponding letters of the long
crossbar and insert the piece into the table frame.
Slide the pieces together, using a mallet if needed.
Continue until the top of the long crossbar is flush
with the rest of the frame.
STEP 6: Insert the (20) keys into the key slots located
on the brackets. Do not screw the keys into place
until step 8.
STEP 7: Place the table top on top of the frame.
Adjust slightly until the grooves on the bottom of the
table align and the table rests properly on the
table frame.
STEP 8: Locate the (20) keys you have already
inserted into the table and screw them into place
using the included Allen screws and Allen wrench.
E
F
I
JK
L
F
G
F
L
R
M
F
I
JK
K
N
LL
R
M
R
Q
K
K
FFL
L
E
A
B
E

SHARE YOUR MEANINGFUL MOMENTS WITH US
ROUTINE CLEANING
Clean with a soft cloth, microfiber towel, or spray
down with a water hose. For a deeper clean, use mild
soap and water with a soft bristle brush.
POWER WASHING
Use caution to avoid inscribing your ping pong table.
Start with a very low PSI at least 3 feet away from
furniture, and test on the under side before moving
closer. Move closer or increase PSI gradually and with
caution until dirt is removed. Check often to ensure
no inscription is left on furniture.
STEP 9: Slide the paddle/ball drawers into place.
STEP 10: Secure the drawers with the T-shaped keys
and screws.
STEP 11: Slide the side of the net with a hook tab into
the notch of the table top. Push down on the other
side to lock into place.
STEP 12: You’re all done! Enjoy your new product and
begin creating life’s most meaningful moments. Tag
us for a chance to be featured!