LEDGE LEGACY ADIRONDACK User manual

REQUIRED TOOLS
IMPORTANT NOTE
The Legacy Adirondack is designed for
on-deck use only.
ASSEMBLY GUIDE FOR
LEGACY
ADIRONDACK
Assemble all screws loosely. Thoroughly tighten all screws in Step 5.
STEP 1: Align the tabs on the Adirondack back with
the slots in the base. Insert with a forceful push
down until secure.
STEP 2: Starting with either side, position the
armrest onto the base, aligning the front screw
holes. Using the hex screwdriver, assemble using (1)
screw in the hole.
HEX SCREWDRIVER(4) SCREWS

YOU INSPIRE US. MARCO! POLO! YOUR TURN...
STEP 3: Align the rear screw holes.
Assemble using (1) screw. ROUTINE CLEANING
For routine cleaning, just use water and a soft cloth
or microfiber towel, or spray down with a water hose.
For a deeper clean, use mild soap and water and a soft
bristle brush.
POWER WASHING
If power washing is desired, start with a low PSI, at
least 3 ft away from furniture. Move closer or increase
PSI gradually and with caution. While power washing,
check often to ensure no inscription is left on the
furniture.
For more information on cleaning & care, please visit
ledgeloungers.com/faq
STEP 4: Repeat steps 2 and 3 for the second armrest.
STEP 5: Thoroughly tighten all 4 screws.