Lee Valley Tools HK330 User manual

Garlic Mincer
(HK330)
The following instructions were provided by the manufacturer.
How to Use
Grasp unit, logo side down; whack
garlic cloves twice to loosen skin.
Put cloves inside and twist back
and forth to mince garlic to desired
texture.
Swivel top unit back and forth to
gather bits neatly into two small
triangles.
Ensure minced garlic is free of the
mincing teeth then open the unit.

Use a table knife to push out
minced garlic for use.
Rinse clean and air dry, or put onto
top rack of dishwasher for
cleaning .
Helpful Hints
1. For quick peeling of garlic, use the Garlic Twist to whack unpeeled cloves 2 to 3 times to loosen
the skin. Grip the tip of the skin and slip it off in whole.
2. For easy mincing, keep the two halves of the Garlic Twist slightly apart while twisting it back and
forth. This would allow the garlic to be shredded layer by layer. This would allow near effortless
mincing of garlic if it is done correctly.
3. For quick and neat gathering of the minced garlic, swivel the top half to one direction until
resistance is felt, then back-swivel it to the other direction until resistance is again felt, then back-
swivel it again slightly to push minced garlic to the center completely free of the mincing teeth
before opening.
4. For best control, use a table knife to push the two chunks of minced garlic out for use.
Last but not least, the Garlic Twist loves garlic, so use a generous amount of crush-peeled
garlic —2, 3 or even four cloves depending on size. Most garlic lovers know the one clove
mentioned in the cook book recipes is just not enough but for the convenience of cooking in the
pre-Garlic Twist days.