Lefroy Brooks M2-1121 User manual

INSTALLATION INSTRUCTIONS
M2-1120
FLEETWOOD CROSS HANDLE 3-HOLE BASIN MIXER
M2-1121
FLEETWOOD LEVER 3-HOLE BASIN MIXER
M2-1121M2-1120

2
Whilst every effort is made to ensure accuracy, design and dimensions are subject to
change without notice as part of the company’s product development process.
M2-1121
M2-1120
Ø2 3/16"
(Ø55mm)
2 15/16"
(75mm)
2 15/16"
(75mm)
1/16"~1 3/16" (1mm)~(30mm)
3 1/8"
(80mm)
1 15/16"
(50mm)
2-1/2-14NPSM-2A
2-9/16-24UNEF-2A
4"
(102mm)
Ø 2 3/16"
(Ø55mm)
Ø2 3/16"
(Ø55mm)
2-G1/2
6"
(152mm)
4 13/16"
(122.7mm)
9 7/16"
(240mm)
1/16"~1 3/16"
(1mm)~(30mm)
6"
(152mm)
1/16"~1 3/16"
(1mm)~(30mm)
2 15/16"
(75mm)
1/16"~1 3/16"
(1mm)~(30mm)
2-9/16-24UNEF-2A
2-G1/2
Ø2 3/16"
(Ø55mm)
Ø 2 3/16"
(Ø55mm)
Ø2 3/16"
(Ø55mm)
3 1/8"
(80mm)
3 1/8"
(80mm)
9 7/16"
(240mm)
4"
(102mm)
4 13/16"
(122.7mm)
2-1/2-14NPSM-2A
Dimensions in Inches (& Millimetres)

3
What you need to know
Adjustable Wrench
Groove Joint Pliers
Hacksaw
Phillips Screwdriver
Pipe Tape
Spatula
Spirit Level
Your new bathroom faucet is designed for years
of trouble-free performance.
Keep it looking new by cleaning it periodically with
a soft cloth. Avoid abrasive cleaners, wire wool and
harsh chemicals as these will dull the finish and
void your warranty.
If you are soldering during faucet installation,
remove cartridges, seats, gaskets and washers
prior to applying flame, otherwise you will void
the warranty.
Cover drain openings to avoid losing small parts.
When cutting or soldering pipe, use safety glasses
to protect your eyes.
Correct installation may vary depending on previous faucet installation. All necessary supplies required for
faucet installation are not included, but may be found where plumbing supplies are sold. It is suggested that
IAPMO and/or CSA approved plumbing supplies are used during installation.
Prior to beginning installation. turn off the cold and
hot water lines and open the old faucet to release
built-up pressure.
Overtightening nuts may cause damage.
Wrap all threaded connections with pipe tape
available at your local plumbing supply store.
Always wrap in a clockwise direction. The fittings
should be installed by a state-licenced plumber.
Tools: Maintenance
Safety Tips
Things You May Need
Important Points
Standards Flow Rate
Please note :
Final achievable flow rate is dependent on the outlets fitted, see relevant outlets (spouts, roses, sprays) for fully
assembled product flow rate.
IAPMO/cUPC Listed (all variants)
Meets NSF 61-9 (all variants)
Meets A112.18.1 (all variants)
ADA Compliant (M2-1121only)
0
1.2
1.4
20 40 60 80PSI

4
4
1
2
3
Install left handle assembly, headwork
cover and side body.
Install other handle assembly, headwork
cover and side body.
Connect flexible hoses. Alternative nuts are
supplied in case you want to connect
copper pipes instead.
Fit spout and install the connector assem-
bly.
43
1 2
Set Screw
Alternative nuts
Steps 1-4
Installation Procedure
Lefroy Brooks always recommends that plumbing products be installed by a licensed professional.
Shut off main water supply before installation.

5
5Remove aerator and turn on water to
remove any left over debris. Re-assemble
aerator.
5
Warning! When installing flexible hose, please notice:
1. There should be no torsion or deformation
2. Do not fold into a V or L shape.
3. Do not use if there is any crack or deformation.
Steps 5
Installation Procedure
Lefroy Brooks always recommends that plumbing products be installed by a licensed professional.
Shut off main water supply before installation.

6
1 Spout assembly (139376W)
2 Oil-seal (010519N)
3 Aerator insert (553661N)
4 Aerator housing (305856-54)
5 Handle (029685H-T)
6 Set screw (075209)
7 O-ring (004026N)
8 Canopy (000113)
9 Escutcheon (071326)
10 O-ring (004072N)
11 Washer (013797)
12 Oil-seal (058094)
13 Washer (013006)
14 Nut (009015)
15 Connector (015004W)
16 Handle (029685C-T)
17 Canopy (018295)
18 Washer (013570)
19 Screw (008486)
20 Clip (012242)
21 Stem extension (110409)
22 Adaptor (057507)
23 Cartridge (507907N)
24 Escutcheon (071473)
25 O-ring (004617)
26 Oil-seal (010017)
27 Washer (013158)
28 Nut (009834)
29 Body (061893W)
30 Flexible hose (105750W)
31 Allen key (031000)
32 Alternative nuts (504003)
1
2
3
4
6
7
8
9
10
11
12
13
14
15
17
20
21
23
24
25
26
27
28
29
30
19
32
16
5
31
22
18
Exploded View
Parts List
M2-1120

7
1 Spout assembly (139376W)
2 Oil-seal (010519N)
3 Aerator insert (553661N)
4 Aerator housing (305856-54)
5 Handle (029686H-T)
6 Cartridge ( H ) (507175N)
7 O-ring (004026N)
8 Set screw (075209)
9 Canopy (000113)
10 Escutcheon (071326)
11 O-ring (004072N)
12 Washer (013797)
13 Oil-seal (058094)
14 Washer (013006)
15 Nut (009015)
16 Connector (015004W)
17 Body (061893W)
18 Handle (029686C-T)
19 Canopy (018295)
20 Washer (013570)
21 Screw (008486)
22 Clip (012242)
23 Stem extension (110409)
24 Adaptor (057507)
25 Cartridge ( C ) (507176N)
26 Escutcheon (071473)
27 O-ring (004617)
28 Oil-seal (010017)
29 Washer (013158)
30 Nut (009834)
31 Alternative nuts (504003)
32 Flexible hose (105750W)
33 Allen key (031000)
19
2
3
4
6
18
7
21
9
10
11
12
13
14
15
16
17
22
23
25
26
27
28
29
30
5
32
31
1
824
20
33
Exploded View
Parts List
M2-1121

For additional assistance or service call
718-302-5292
9am to 5pm EST Monday to Friday
LEFROY BROOKS INC, 1828 TROUTMAN STREET, RIDGEWOOD, NY, 11385
TELEPHONE: [phone]. FAX: [phone]
The use of trademarks, product design and artwork is subject to licence or agreement with LBIP Ltd. The design
registrations, trademark registrations and copyrights are protected by law and the use or reproduction outside the terms of an agreement is prohibited.
The right to modify designs and dimensions is reserved. Christo Lefroy Brooks is a member of ACID (Anti Copying in Design).
© LBIP LTD 2012
www.lefroybrooks.com