Legend Scenario Contol 5739 02 User manual

Part. U3327A - 11/08-01 PC
User manual
5739 02
5739 03
Scenario control

Contents UK
3
The Scenario Control■4
General information✔4
Description✔4
Mode of operation
■5
To program a scenario✔5
To cancel a scenario✔6
How your Scenario Control is congured
✔6

1 - Introduction
The Scenario Control■
The Scenario Control is a device which lets you call, create or edit scena-
rios saved in an 0035 51 Scenario Module, simply and intuitively.
Using the labels you can customise the device keys, inserting a descrip-
tion of the scenario activated.
Description✔
General information✔
2
1
3
4
5
6
* To set the brightness of the key LEDs press them for more than two
seconds as shown in the diagram.
100%
0%
30%
60% PUSH
DEFAULT
*
1– 4• Control keys
5• Brightness setting pushbutton *
6• Customised label
4

2 - Use
DEL
035 51
Mode of operation■
Your Scenario Control can program up to four scenarios, saving
them in a Scenario Module (0035 51) which has been enabled for
programming.
To program a scenario✔
To save one or more scenarios:
In the Scenario Module press the pro-
gramming enabling pushbutton.
Its led becomes green:
the module is enabled.
Press the key to program for more than
four seconds.
When the led lights up release the
key.
The led flashes to indicate that the pro-
gramming mode has been activated.
t > 4 s
Set the sequence of commands which
make up the scenario.
ON
OFF
luce cinema
notte relax
Repeat the sequence to add, edit or cancel a scenario command.
Press the key to end the programming.
Press the corresponding key to activate
the scenario required.
luce cinema
notte relax
luce cinema
notte relax
At the end of the programming you should disable the possi-
bility of editing the scenarios by pressing the Scenario Module
(0035 51) enable/disable pushbutton. The led becomes red.
ON
OFF
on
on
5

2 - Use
Follow the procedure described below to cancel a scenario.
To cancel a scenario✔
To cancel one or more scenarios:
DEL
035 51
luce cinema
notte relax
Now if the led flashes quickly for about two seconds the scenario has
been cancelled. If it continues to shine steadily the procedure has not
been successful.
Use the Scenario Module (0035 51) reset pushbutton to cancel
all its scenarios.
How your Scenario Control is congured✔
SCENARIO NAME SCENARIO DESCRIPTION
1
2
3
4
21
43
t > 8 s
To cancel a scenario press the key for
the scenario to be removed for at least
eight seconds.
After three seconds the led lights up
and after five seconds it goes out.
Release the key.
In the Scenario Module press the pro-
gramming enabling pushbutton.
Its led becomes green:
the module is enabled.
6

Legrand
reserves at any time the right to modify the contents of this booklet and to communicate, in any form
and modality, the changes brought to the same.
Installer stamp
World Headquarters and
International Department
87045 LIMOGES CEDEX FRANCE
: 33 5 55 06 87 87
Fax : [phone]
www.legrandelectric.com