
Revisions to the design reserved
3
Attaching the LEGI R gratings and completing the bolted connections
Attach the gratings for the LEGI R sys-
tem overlapping in the pre-tted hook
bolts, during which the gratings can be
tted optionally with the projecting wire
ends upwards or downwards.
Tighten the nuts of the hook bolts hand-
tight so that the gratings can still be ad-
justed without difculty.
Make the lacking bolted connections
as described in . However, these can
be rmly tightened.
4
5
Alternatively:
Attach the gratings to the LEGI-pur
assembly aid. Remove the assembly aid after
fastening a hook bolt.
or
2
Press the ribbed stoppers LAW 1460 into
the holes to cover them. Press the post
cap into the cross-section of the post. Use
a rubber mallet to avoid damage.
Non-stepped height difference with LEGI clamping plate SK
Note:
The LEGI clamping plate SK is used for
non-stepped height differences of the
grating on the post. The required number
of clamping plates for each post is equal
to the number of used hook bolts.
Completing the bolted connections
Attaching the gratings
patented
2www.legi.de
R pur
LEGI fence system