Lekker Bikes Amsterdam GT User manual

Front rack installation manual -
Amsterdam GT
This step-by-step manual will guide you through the installment of your
LEKKER front carrier. You will need allen keys sizes 4mm and 5mm, a
crosshead screwdriver and a 8mm wrench.
Please note: For the proper installation of the front rack, you need to
remove the front light from its original placement and place it on the
handlebar stem cap with light holder (see picture below). This cap is
unfortunately only available from the 2nd week of August onwards. We will
ship you the cap separately. Only once you receive this cap, can you install
the rack and lamp correctly. We recommend waiting with the installation of
your front rack until you receive this cap!

Step 1
Using two 5mm allen keys,
loosen and remove the bolt that
runs through the front fork and
holds your lamp and fender. You
can now remove the lamp from
the bolt. Do not disconnect the
cables, since it has to be
repositioned after the front rack is
installed.
Step 2
Next, re-attach the bolt you have removed
in step 1 using the two 5mm allen keys.
Hook the carrier onto the bolt before
fastening it tightly.

Step 3
Now, attach the front carrier stays to the carrier
using the provided bolt, nut and washers.
Step 4
To attach the stays to the
fork, first remove the bottom
black bolt using a 4mm
allen key. After, attach the
carrier stays by inserting
and tightening this bolt
again.
Now your bike should approximately look
like this.

Step 5
Before you proceed, please consider
which position you would like the lamp
to be in. We recommend the upper
position for better water resistance
and the lamp not being in the way of
the cables.
Step 6
Use your 4mm allen key to
loosen the four bolts at the front
cap of the handlebar. Please
keep in mind that this will
temporarily separate the
handlebar from the handlebar

stem, so hold the handlebars in place.
Step 7
When attaching the new
front cap, which will hold
the lamp, make sure
that it is positioned
according to your choice
in step 5. Then fasten
the four bolts using a
4mm allen key.
Step 8
Before the lamp can be attached to the new
handlebar cap, remove it from the original
lamp holder using a cross-headed
screwdriver and a 8mm wrench.

Step 9
Then, install the lamp on the cap on
your handlebar. Your choices in
earlier steps will determine if the
lamp will be located on top of the
handlebar (such as in the picture to
the right) or below.
Congratulations,
You have now successfully installed your LEKKER bikes front carrier and
re-located the lamp accordingly.