LeMaitre BubbleMaster 2000 User manual

Bubble Master 2000
V.12.15.00

Page 1 Technical Specifications
Page 2 Warning
Page 3 Operating Procedure
Page 4 Bu leMaster 2000 Control Features
Page 5 Shut Down Procedure
Page 5 Trou le Shooting the Bu leMaster 2000
Page 6 Maintenance
Page 6 Safety Precautions
Page 7 Warranty
Page 8 Accessories
Please Read Carefully Before Operating
Table of Contents

Technical Specifications
Model: Bu leMaster 2000
Type: Water Base Bu le generating system
Size: 723 x 412 x 406 mm. High (Incl. Bu le Projector)
28 1/2x 16 x 16 1/4 High (Incl. Bu le Projector)
Weight: 21 L s. 9.51 Kg.
Power Rating: 115 Volt A.C. 50/60 Hz 1 Amps
220 Volt A.C. 50/60 Hz 0.5 Amps
BubbleMaster 2000 Illustration
1

M.S.D.S. Available by request or at .lemaitrefx.com
WARNING
READ THESE IMPORTANT SAFETY INSTRUCTIONS
Do ot remove the outer case u til power has bee
disco ected from the machi e
WARNING
E sure that this u it is grou ded at all times.
Failure to do so may result i serious i jury.
WARNING
Warning
Never use alter ative fluids. Toxicity free output
is your respo sibility.
2

Operating Procedure
Unpack the Bu le Master
2000 and inspect all compo-
nents. Although the packag-
ing was designed for the
rigours of todays parcel deliv-
ery sevices, damage may have
occurred during shipping.
1.) Prior to operation, the
extension sleeve may e
placed over the u le outlet.
This will allow the u les to
e projected higher, efore
they egin to disperse outwards.
For lower flying u les do not use the extension sleeve.
2.) Place the Bu le Master 2000 on a level sturdy surface, or use the optional adjusta le
stand sold separately.
3.) Open a container of Le Maitre Bu leMaster 2000 Bu le Fluid, and pierce the foil top.
Pour the fluid into the u le outlet. Fill up to 1/2 elow the resevoir top. This initially
should take approximately 1 gallon.
4.) Plug the Bu leMaster 2000 into an outlet that is capa le of sustaining the current
load listed on the product serial plate.
Setup
3

1. Power up unit y connecting to suita le power supply
2. Upon power up the display will read" LE MAITRE FX BUB-
BLE 2000" for 2-5 seconds .
3. The Main Menu will e displayed. The Main Menu will indicate System Status (ON or
OFF), Fan Status (ON or OFF), and the current Speed Setting (0 to 99).
4. Pressing the START/STOP/ENTER keypad at the Main Menu will change the setting to
System Status ON or OFF.
5. To select the Fan Speed Menu, Bu le On Menu, Bu le Off Menu, or Main Menu
press the Previous Menu or Next Menu keypads until the appropriate menu is displayed.
6. To change the value of the Fan Speed, Bu le On Time, or Bu le Off Time settings
use the 'Increase or 'decrease' keypads, the ne setting ill be saved by pressing the
START/STOP/ENTER keypad.
BubbleMaster 2000 Controls
4

Troubleshooting BubbleMaster 2000
Shut Do n Procedure
1.) Disconnect the Bu leMaster 2000 from the power source.
2.)Remove the u le extension sleeve if used..
3.) Using a funnel, empty the contents of the fluid reservoir ack into the
1 gallon fluid container. This can e done y tipping the unit, and pour-
ing the fluid out of the u le outlet.
4.) Replace cap on the fluid container to keep dirt and de ris from
entering.
5.) Rinse out fluid reservoir and u le wheels with hot tap water tap
water to remove excess Bu le fluid residue. Using a paper towel wipe
out extension sleeve and u le oulet.
Empty into sink or appropriate drain.
Bubble Wheel not turning:
Ensure that set screws are secure in u le wheel motor shaft.
Intermittent bubbles produced.
Ensure that there is enough fluid in the fluid reservoir, and that the u le wheels are
eing su mersed in u le fluid.
5

Safety Precautions
1. Ensure that operation of the machine is supervised y suita ly trained and authorised
personnel.
2. Do not modify the machine or use a machine which has een damaged in any way.
3. Allow sufficient air circulation around the machine at all times.
4. Protect the Bu leMaster 2000 from direct weather effects and wet locations.
5. Use only Le Maitre Special Effects Bu le Master 2000 u le fluid.
6. Avoid direct u le output continuously at persons, structure or o jects within close
proximity of the discharge nozzle.
7.) Do not allow any liquid to spill into or on the remote control or the cover ehind the
remote.
Maintenance
Fluid Reservoir
Bubble Wheels
When storing the Bu le Master 2000 for any extended period, e sure to thoroughly
rinse the fluid reservoir.
When storing the Bu le Master 2000 for any extended period, e sure to thoroughly
rinse u le wheels.
6

Warranty:
All warranty is one year parts and la our unless specified and is on
manufacturer defect only. Overuse or poor maintenance is not
accepted. Le Maitre fluids must always e used. Accept no su sti
tutions as there are no exceptions to this rule. Proof of purchase or
proof of sale must always accompany any warranty returns. An
RA (return authorization) num er must e noted on the outside of
any ox returned to our facilities. Any packages without a clearly
marked RA num er will not e accepted y our receiving depart
ment. Freight on warranty items are freight prepaid to our facility
and we will prepay freight ack to your facility after repair, y the
most economical means availa le. Should you require the item
express-returned, then you are responsi le for any difference in
freight cost.
Return Policy:
Return of any product must e done within 30 days of purchase.
The package must e returned freight prepaid and the RA num er
clearly marked on the outside of the ox. A restocking charge of
up to 25% may e levied. Only credits are issued to the dealers
account. Any product not returned within 30 days is considered
purchased.
Warning:
Le Maitre Special Effects Inc. considers all it's product to e safe
for use in the application it was intended. Le Maitre Special
Effects takes no responsi ility for misuse or incorrect use. Always
refer to equipment owners manual for proper use.
Warranty
7

Accessories
Recommended Fluid
Use only Le Maitre Special Effects Bu le Master 2000 Bu le Fluid. This iodegrada le
fluid has een formulated to deliver long lasting dryer u les that almost dry on con-
tact.
8
Model Description
CLF 2944 DMX Interface
CLB 2005 Bubble Stand Mountin
g
n
g
Plate
CLB 2007 Bubble Machine Stand
CLB 2004 Bubble Wall Mountin
g
n
g
Plate
CALL Bubble Machine Han
g
n
g
in
g
Bn
g
Bracket
CLB 2004 Bubble Securin
g
Bn
g
Bracket
CLB 2006 Bubble FDS Option
CLF 3100 20 L. Pail Han
g
n
g
in
g
Bn
g
Bracket
CPH PC001 5 Pin DMX/ Bubble Remote Cable 25'
CPH PC005 5 Pin DMX/ Bubble Remote Cable50'
CPH PC007 5 Pin DMX/ Bubble Remote Cable100'

Notes
9