Lennox Elite series User manual

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE 1
TRADITIONAL FACE KITS
MODELS RAVENNA™ AND DESIGNER™
INSTALLATION INSTRUCTIONS FOR INSTALLING TRADITIONAL FACE KITS FOR
USE WITH THE RAVENNA 33/40 AND DESIGNER GAS FIREPLACE INSERTS
775254M
Rev. B, 11/2010
HEARTH PRODUCTS
KITS AND ACCESSORIES
KIT CONTENTS (See Figure 1)
Please ensure that all these parts are included
1 ea. Face
1 ea. Instruction Sheet
INSTALLATION INSTRUCTIONS
Installation of the surround assembly is required prior to installing the
Traditional Face Kit. Install the surround assembly per instructions in
the installation and operation manual provided with the fireplace insert.
Step 1. Install the face onto the surround brackets as shown in Figure
2. Each side of the face has a bracket with two (2) hooks. Place
the face on the surround hanging brackets as seen in Figure 2
by placing the hooks on position C.
IMPORTANT: If you have a gold or nickel face, be sure and clean
the face with a soft cloth and household glass cleaner prior to
burning the insert. Finger prints left on the face while burning
will usually remain on the face permanently.
Figure 1 - Traditional Face Kit Contents
Traditional Face Kits
Cat. No. Model Description
75167 DBV-RDV F-B G Black Face / Gold Trim
75168 DBV-RDV F-G Gold Face
75006 DBV-RDV TRDF-BKN Black Nickel Face
75045 DBV-RDV TRDF-BN Brushed Nickel Face
TOOLS NEEDED
3/8” Nutdriver or Wrench
Phillips Screwdriver
GENERAL INFORMATION
All of these parts may scratch and bend, great care should be used
in handling them.
If you encounter any problems, need clarification of these instructions
or are not qualified to properly install this kit, contact you local distribu-
tor or dealer.
Read this instruction sheet in its entirety before beginning the installation.
ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND
OPERATION MANUAL PROVIDED WITH THE APPLIANCE APPLY TO
THESE INSTRUCTIONS.
TURN OFF THE FIREPLACE AND ALLOW IT TO COMPLETELY COOL
BEFORE PROCEEDING.
fire-parts.com

2
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE
Printed in U.S.A. © 2010 Lennox Hearth Products
P/N 775254M REV. B 11/2010
Lennox Hearth Products reserves the right to make changes at any time, without notice, in
design, materials, specifications, prices and also to discontinue colors, styles and products.
Consult your local distributor for fireplace code information.
1508 Elm Hill Pike, Suite 108 • Nashville, TN 37210
Surround panel kit sold separately
Figure 3 - Completed Installation
A
C
Figure 2
B
A = Speed nuts
B = Holes in the surround brackets - three on each side
C = Location where hooked brackets on face will hang
The face has two hooks on each side that slide over and hang on the
surround brackets at position C shown here. The face may slide slightly
from side to side to center the face on the glass.
B
CAUTION: WHEN OPENING THE LOWER DOOR ON THE TRADITIONAL
FACE WHILE THE INSERT IS BURNING, ONE SHOULD PULL AT THE FAR
LEFT OR FAR RIGHT VENT OPENINGS AS THE DOOR IS HOT DURING
OPERATION.
fire-parts.com