Let's Go Aero V-Tree 4 User manual

Page 1 of 4
V-Tree™ 4
Four Bike Vertical V-Rack™ Floor Stand
Part No. B00284
Revision Date: 12/12/19VT4-B00284-121219Rev
ASSEMBLY, INSTALLATION, AND OPERATION INSTRUCTIONS
NOTICE: All Manual information is subject to change without notice. Revised editions
will be available for free download at LetsGoAero.com. Manual information is considered
factual until made obsolete by a revised version.
Follow this QR-Code or visit
LetsGoAero.com/manuals to check for an updated version:
Copyright© 2019, Lets Go Aero, Inc., All rights reserved.
PRODUCT MANUAL
To register your product,
visit the LetsGoAero.com/registration
For More Information & Accessories,
Visit our Website - www.LetsGoAero.com
For Technical Support & Product Questions Contact Us:
877-464-2376 or 719- 630-3800
Let’s Go Aero, Inc. 4474 Barnes Road
Colorado Springs, CO 80917, USA
Patent and trademark protected:
Patent Number 8,889,456; Patents Pending
A
B
C
D
E
F
G
H
I
J
1
2
12
8
2
1
1
4
8
8
BASE
LEG
6MM BOLT
6MM NUT
PLASTIC SEPARATOR
RISER
UPPER SUPPORT
WING SUPPORT ARMS
WHEEL CRADLE
RETAINER CLIP
QTY. DESCRIPTION
PARTS

Page 2 of 4
STEP 1:
STEP 2:
STEP 3:
Connect both Legs [B] to
the Base [A] using two (2)
6mm Bolts [C] and one (1)
Plastic Separator [E] to
secure each Leg as shown.
[Fg. 1]
Align the holes on the Riser [F] to the holes located on the vertical bracket of the
Base [A]. Secure the Riser to the Base using two (2) 6mm Bolts [C] and two (2) 6mm
Nuts [D]. [Fg. 2 & 3]
In the same manor as Step 2, align the
holes on the Upper Support [G] to the
holes located on the Riser [F]. Secure the
Upper Support to the Riser using two (2)
6mm Bolts [C] and two (2) 6mm Nuts [D].
[Fg. 4 & 5]
[Fg. 1]
[Fg. 2]
[Fg. 4] [Fg. 5]
[Fg. 3]
C
C
D
D
F
F
F
C
A
A
C
E
B
E
C
A
G
D
B
C
C
C
C
G
F

Page 3 of 4
STEP 4:
STEP 5:
OPERATION: BICYCLE MOUNTING
Using the holes located at the top of the Wing [H], insert
two (2) Wheel Cradles [I] into the Wing facing in opposite
directions.
Secure each Wheel Cradle [I] with a Retainer Clip [J].
[Fg. 8]
A
E
G
G
H
D
I
IJ
J
C
A
H
H
H
FOAM BUMPERS
[Fg. 7]
[Fg. 8]
[Fg. 9]
[Fg. 6]
H
Slide the Foam Pads on the Wings [H]
down to reveal the holes near the edge
of the Wing.
Align the holes on the edge of the Wing
[H] with holes located on the Base [A]
and the Upper Support [G]. [Fg. 6]
Secure the Wings [E] to the Base [A]
and Upper Support [G] using one (1)
6mm Bolt [C] and one (1) 6mm Nut [D]
per Wing as shown. [Fg. 7]
Hang bicycles by the tires on the Wheel
Cradles [I] with the chain rings to the
outside. [Fg. 9]
Adjust the Foam Bumpers located on
the Wings [H] to protect the frame of the
bicycle.

Page 4 of 4
OPERATION: BICYCLE MOUNTING
[Fg. 10] [Fg. 11] [Fg. 12] [Fg. 13]
IMPORTANT: For two bicycles, position the bicycles facing in opposite directions (front-to-back/back-to-front) with the
chain ring to the outside.
IMPORTANT: Always LOAD bicycles starting with the LOWER SECTION of the V-Tree 4 rst.
IMPORTANT: When UNLOADING start from the UPPER SECTION rst.
IMPORTANT: ALWAYS ENSURE WEIGHT IS PRIORITIZED TO THE LOWER SECTION TO AVOID TIPPING.
TIP: Some adjustment of the Wheel Cradles may be necessary in order to accommodate both bicycles in each section.
Never exceed the maximum 60 lbs per bicycle weight rating on the LOWER SECTION and the maximum 40lbs per
bicycle weight rating on the UPPER SECTION. ALWAYS LOAD THE LOWER SECTION FIRST. Always prioritize
weigh to the lower section. Do not stand, sit, climb, or hang or use the V-Tree for any other purpose than intended.
CAUTION:
If a Let’s Go Aero bike rack is found to have a defect in workmanship or material over the lifetime of the original purchaser, Let’s Go
Aero will repair or replace the defect free of charge. This warranty terminates if a purchaser transfers the product to any other person.
The warranty does not cover damage or wear which occurs as a result of day to day use or general wear and tear. No warranty is given
for defects caused by normal wear and tear, cosmetic rust, scratches, accidents, unlawful vehicle operation, or modication of, or any
types of repair of, a load carrier system other than those authorized by Let’s Go Aero.
No warranty is given for defects resulting from conditions beyond Let’s Go Aero’s control including, but not limited to, misuse, overload-
ing, or failure to assemble, mount or use the product in accordance with Let’s Go Aero’s written instructions or guidelines included with
the product or made available to the purchaser.
Subject to the limitations and exclusions described in this warranty, Let’s Go Aero will remedy defects in materials or workmanship by
repairing or replacing any parts diagnosed to be at issue without charge for parts or labor. In the event that a product is defective, the
purchaser should contact the Let’s Go Aero dealer from whom the product was purchased. If the dealer is not able to correct the defect,
the purchaser should contact Let’s Go Aero in writing to [email protected] or by phone at 877-464-237 or 719-630-3800.
In the event that a product needs to be returned to Let’s Go Aero, a Let’s Go Aero technician will provide the purchaser with the appro-
priate mailing address and any additional instructions. Proof of purchase in the form of an original purchase invoice or receipt, and a
detailed description of the defect must be provided. Please note that a Return Merchandise Authorization (RMA) from Let’s Go Aero is
required for any returns.
DISCLAIMER OF LIABILITY REPAIR OR REPLACEMENT OF A DEFECTIVE PRODUCT OR THE ISSUANCE OF A REFUND OR
CREDIT (AS DETERMINED BY LET’S GO AERO) IS A PURCHASER’S EXCLUSIVE REMEDY UNDER THIS WARRANTY. DAMAGE
TO A PURCHASER’S VEHICLE, CARGO AND/OR TO ANY OTHER PERSON OR PROPERTY IS EXCLUDED.
THIS WARRANTY IS EXPRESSLY MADE IN LIEU OF ANY AND ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
LET’S GO AERO’S SOLE LIABILITY TO ANY PURCHASER IS LIMITED TO THE REMEDY SET FORTH ABOVE. IN NO EVENT WILL
LET’S GO AERO BE LIABLE FOR ANY LOST PROFITS, LOST SALES, OR FOR ANY CONSEQUENTIAL, DIRECT, INDIRECT, INCI-
DENTAL, SPECIAL, EXEMPLARY, OR PUNITIVE DAMAGES OR FOR ANY OTHER DAMAGES OF ANY KIND OR NATURE.
SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE
ABOVE LIMITATIONS MAY NOT BE APPLICABLE. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO
HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.
LET’S GO AERO LIMITED LIFETIME WARRANTY
This manual suits for next models
1
Table of contents
Other Let's Go Aero Rack & Stand manuals