LevelOne FCS-1141 User manual

LevelOne IP Camera
Wired/Wireless Network Camera
Quick Installation Guide

Page
1
This guide covers only the most common situations. All detail
information is described in the user manual.
Viewing System Requirements
Windows 2000,XP, VISTA, Windows7 operating systems
Browser: Internet Explorer 6.0 or above
NOTE:
All the captured images of installation mentioned in this user manual
were based on Windows VISTA operating system. For installation on
other Windows OS, e.g. Windows XP, all the procedures remain the
same.
Figure 1-1
Figure 1-2

Page
2
Figure 1-3
Figure 1-4
Figure 2-1

Page
3
Figure 2-2
Figure 2-3
Figure 3-1

Page
4
Using the Software CD to configure the camera
Power on your PC and insert the CD-ROM
The setup page should load automatically. If it does not, please
select your CD-ROM drive manually to open the setup page.
Select “Install Software”->” Device Search” (Figure1-1&1-2 )
Run “Device Search”. (Figure 1-3)
The Device Search will show MAC address and an IP Address
of available LevelOne Network Cameras. Highlight the MAC
address and double click to link to the selected device.(Figure
1-4)
Enter ‘root’ for the name, and leave the password blank.
(Figure 2-1)
The following screen would appear automatically. Click “Next”
and proceed.(Figure 2-2)
Congratulations, you can use the camera through the network
to view the video.(Figure 2-3)
Installing IP CamSecure
Click ”IP CamSecure” and follow the onscreen instruction or refer to
the user’s manual to complete installation.(Figure 3-1)