LG Magic Remote AN-MR18VV User manual
Please read this manual carefully before using your remote and retain it for future reference.
OWNER’S MANUAL
Magic Remote
AN-MR18VV
www.lg.com
Printed in Korea
Copyright © 2017 LG Electronics Inc. All Rights Reserved.
(1712-REV00)
*MFL70421601*
2
ENGLISH
• Contents in this manual may be changed without prior notice due to upgrade of
product functions.
ACCESSORIES
The remote control image shown may differ from the actual product.
Magic Remote and Alkaline Batteries (AA) Owner’s manual
BATTERY
1 Installing Batteries
• Please read this manual carefully.
• Press the top of the battery cover, slide it back,
and lift the cover as shown below.
• To replace batteries, open the battery cover,
replace alkaline batteries (1.5 V, AA) matching
and ends to the label inside the compartment,
and close the battery cover. Be sure to point the
remote control at the remote control sensor
on the TV.
• To remove the batteries, perform the installation
actions in reverse. Don’t mix old or used batter-
ies with new ones. Close the cover securely.
• Open the battery cover to find the label.
2 Precautions
• After replacement of the batteries, pair the remote control and use it in accord-
ance with user manual.
• If the unit does not operate after replacement of batteries, reattempt pairing in
accordance with the user manual.
• If the remote controller is not being used for prolonged period of time, remove
the batteries from the unit.
• Do not dismantle or expose the batteries to heat.
• Do not drop or exert extreme impact on the batteries. This may cause the case
to be damaged.
• Do not immerse the batteries in water.
• There is danger of explosion if batteries are inserted incorrectly.
• Properly dispose of used batteries.
• Failure to match the correct polarities of the battery may cause the battery to
burst or leak, resulting in re, personal injury, or ambient pollution.
3
ENGLISH
• Contents in this manual may be changed without prior notice due to upgrade of
product functions.
ACCESSORIES
The remote control image shown may differ from the actual product.
Magic Remote and Alkaline Batteries (AA) Owner’s manual
BATTERY
1 Installing Batteries
• Please read this manual carefully.
• Press the top of the battery cover, slide it back,
and lift the cover as shown below.
• To replace batteries, open the battery cover,
replace alkaline batteries (1.5 V, AA) matching
and ends to the label inside the compartment,
and close the battery cover. Be sure to point the
remote control at the remote control sensor
on the TV.
• To remove the batteries, perform the installation
actions in reverse. Don’t mix old or used batter-
ies with new ones. Close the cover securely.
• Open the battery cover to find the label.
2 Precautions
• After replacement of the batteries, pair the remote control and use it in accord-
ance with user manual.
• If the unit does not operate after replacement of batteries, reattempt pairing in
accordance with the user manual.
• If the remote controller is not being used for prolonged period of time, remove
the batteries from the unit.
• Do not dismantle or expose the batteries to heat.
• Do not drop or exert extreme impact on the batteries. This may cause the case
to be damaged.
• Do not immerse the batteries in water.
• There is danger of explosion if batteries are inserted incorrectly.
• Properly dispose of used batteries.
• Failure to match the correct polarities of the battery may cause the battery to
burst or leak, resulting in re, personal injury, or ambient pollution.
4
ENGLISH
REMOTE DESCRIPTION
• The remote control image shown may differ from the actual product.
• The order of description may differ from the actual product.
• Some buttons are not available for all models.
(Power) Turns the TV on or off.
(Compass) Execute SI app. (If the SI app is
not installed, this button works as
the Home key).
(Home) Accesses the Home menu.
Returns to the previous screen.
Activates or deactivates the
subtitles.
(Q. Settings) Accesses the quick settings.
(Mute) Mutes all sounds.
(Voice
recognition)
Network connection is required to use
the voice recognition function.
1. Press the voice recognition button.
2. Speak when the voice display win-
dow appears on the TV screen.
Adjusts the volume level.
Scrolls through the saved channels.
Press the up, down, left or right
button to scroll the menu. If you press
buttons while the pointer
is in use, the pointer will disappear
from the screen and Magic Remote will
operate like a general remote control.
To display the pointer on the screen
again, shake Magic Remote to the left
and right.
Selects menus or options and conrms
your input.
5
ENGLISH
REMOTE DESCRIPTION
• The remote control image shown may differ from the actual product.
• The order of description may differ from the actual product.
• Some buttons are not available for all models.
(Power) Turns the TV on or off.
(Compass) Execute SI app. (If the SI app is
not installed, this button works as
the Home key).
(Home) Accesses the Home menu.
Returns to the previous screen.
Activates or deactivates the
subtitles.
(Q. Settings) Accesses the quick settings.
(Mute) Mutes all sounds.
(Voice
recognition)
Network connection is required to use
the voice recognition function.
1. Press the voice recognition button.
2. Speak when the voice display win-
dow appears on the TV screen.
Adjusts the volume level.
Scrolls through the saved channels.
Press the up, down, left or right
button to scroll the menu. If you press
buttons while the pointer
is in use, the pointer will disappear
from the screen and Magic Remote will
operate like a general remote control.
To display the pointer on the screen
again, shake Magic Remote to the left
and right.
Selects menus or options and conrms
your input.
6
ENGLISH
USING
How to register (pair) or deregister (unpair)
How to register (pair) the Magic Remote
To use the Magic Remote, rst pair it with your TV.
1 Put batteries into the Magic Remote and turn
the TV on.
2 Point the Magic Remote at your TV and press the
(Voice recognition) on the remote control.
- If the TV fails to register the Magic Remote, try
again after turning the TV off and back on.
How to deregister (unpair) the Magic Remote
1 Press the (Home) and buttons at the
same time, for ve seconds, to unpair the Magic
Remote with your TV.
PRECAUTIONS TO TAKE
• Use the remote control within the specied range (within 10 m (32.8 ft)).
• You may experience communication failures when using the device out-
side the coverage area or if there are obstacles within the coverage area.
• You may experience communication failures depending on the accessories.
• Devices such as a microwave oven and wireless LAN operate in the
same frequency band (2.4 GHz) as the Magic Remote. This may cause
communication failures.
• The Magic Remote may not work properly if a wireless router (AP) is
within 1 m (3.28 ft) of the TV. Your wireless router should be more than 1
m (3.28 ft) away from the TV.
• Do not disassemble or heat the batteries.
• Do not drop the battery. Avoid extreme shocks to the battery.
• Inserting a battery in the wrong way may result in explosion.
7
ENGLISH
USING
How to register (pair) or deregister (unpair)
How to register (pair) the Magic Remote
To use the Magic Remote, rst pair it with your TV.
1 Put batteries into the Magic Remote and turn
the TV on.
2 Point the Magic Remote at your TV and press the
(Voice recognition) on the remote control.
- If the TV fails to register the Magic Remote, try
again after turning the TV off and back on.
How to deregister (unpair) the Magic Remote
1 Press the (Home) and buttons at the
same time, for ve seconds, to unpair the Magic
Remote with your TV.
PRECAUTIONS TO TAKE
• Use the remote control within the specied range (within 10 m (32.8 ft)).
• You may experience communication failures when using the device out-
side the coverage area or if there are obstacles within the coverage area.
• You may experience communication failures depending on the accessories.
• Devices such as a microwave oven and wireless LAN operate in the
same frequency band (2.4 GHz) as the Magic Remote. This may cause
communication failures.
• The Magic Remote may not work properly if a wireless router (AP) is
within 1 m (3.28 ft) of the TV. Your wireless router should be more than 1
m (3.28 ft) away from the TV.
• Do not disassemble or heat the batteries.
• Do not drop the battery. Avoid extreme shocks to the battery.
• Inserting a battery in the wrong way may result in explosion.
8
ENGLISH
SPECIFICATIONS
CATEGORIES DETAILS
Model No. AN-MR18VV
Range of frequency 2.4 GHz to 2.4835 GHz
Output Power (Max.) 4 dBm
Channel 40 channels
Reception sensitivity -94.5 dBm
Dimensions
Width 48.3 mm x Length 183.5 mm x
Thickness 33.7 mm
(Width 1.9 inches x Length 7.2 inches x
Thickness 1.3 inches)
(Tolerance of ± 1 mm (0.03 inches))
Weight 91 g ± 8 g (0.2 lbs ± 0.01 lbs)
(Excluding batteries)
Power source AA 1.5 V, 2 alkaline batteries are used
Power consumption 300 mW
Operational temperature range 0 °C to 60 °C (32 °F to 140 °F)
• FCC ID: BEJMR650A
FCC NOTICE
Federal Communications Commission (FCC) Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency en-
ergy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received, including interference that
may cause undesired operation of the device of the device.
You are cautioned that changes or modications not expressly approved by the
part responsible for compliance could void the user’s authority to operate the
equipment.
9
ENGLISH
SPECIFICATIONS
CATEGORIES DETAILS
Model No. AN-MR18VV
Range of frequency 2.4 GHz to 2.4835 GHz
Output Power (Max.) 4 dBm
Channel 40 channels
Reception sensitivity -94.5 dBm
Dimensions
Width 48.3 mm x Length 183.5 mm x
Thickness 33.7 mm
(Width 1.9 inches x Length 7.2 inches x
Thickness 1.3 inches)
(Tolerance of ± 1 mm (0.03 inches))
Weight 91 g ± 8 g (0.2 lbs ± 0.01 lbs)
(Excluding batteries)
Power source AA 1.5 V, 2 alkaline batteries are used
Power consumption 300 mW
Operational temperature range 0 °C to 60 °C (32 °F to 140 °F)
• FCC ID: BEJMR650A
FCC NOTICE
Federal Communications Commission (FCC) Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency en-
ergy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received, including interference that
may cause undesired operation of the device of the device.
You are cautioned that changes or modications not expressly approved by the
part responsible for compliance could void the user’s authority to operate the
equipment.
10
ENGLISH
FCC Caution
Any changes or modications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment and For
indoor use only, use outdoors or in other modes not covered by this manual may
violate the FCC regulation and violate the user authority to use the product.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an un-
controlled environment. End users must follow the specic operating instructions
for satisfying RF exposure compliance.
LG Recycling Policy
LG Electronics offers a customized e-waste take-back and recycling service that
meets local needs and requirements in the countries where e-waste regulations
are in place, and also provides product and packaging take-back and recycling ser-
vice voluntarily in some countries. LG Electronics evaluates products’ recyclability
at the design step using LG’s recyclability evaluation tool, with the goal of improv-
ing recyclability where practicable. Through these activities, LG seeks to contribute
to conserving natural resources and protecting the environment.
For more information about the LG Recycling Policy, please visit our global site at
http://www.lg.com/global/sustainability/environment/take-back-recycling
11
ENGLISH
FCC Caution
Any changes or modications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment and For
indoor use only, use outdoors or in other modes not covered by this manual may
violate the FCC regulation and violate the user authority to use the product.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an un-
controlled environment. End users must follow the specic operating instructions
for satisfying RF exposure compliance.
LG Recycling Policy
LG Electronics offers a customized e-waste take-back and recycling service that
meets local needs and requirements in the countries where e-waste regulations
are in place, and also provides product and packaging take-back and recycling ser-
vice voluntarily in some countries. LG Electronics evaluates products’ recyclability
at the design step using LG’s recyclability evaluation tool, with the goal of improv-
ing recyclability where practicable. Through these activities, LG seeks to contribute
to conserving natural resources and protecting the environment.
For more information about the LG Recycling Policy, please visit our global site at
http://www.lg.com/global/sustainability/environment/take-back-recycling
Table of contents
Other LG Portable Stereo System manuals
