LG FH0H3NDNL 2 Series User manual

WASHING
MA CHINE
P/NO : MFL67584563
Please read this manual carefully before operating
your washing machine and retain it for future reference.
FH0H3NDNL(0~9)2
FH0G7NDNL(0~9)2
Rev. No.: 00_03/03/2017
FH0G6WDNL(0~9)2
FH2G6HDNL(0~9)2
FH2G7NDNL(0~9)2
MFL67584563
FH0G7WDNL(0~9)2
Copyright © 2017 LG Electronics. All rights reserved.

No Spin/400/800/1000/1200 : [FH2G7NDNL(0~9)2/FH2G6HDNL(0~9)2]
No Spin/400/600/800/1000 : [FH0H3NDNL(0~9)2/FH0G7NDNL(0~9)2/
6.0kg :[FH0H3NDNL(0~9)2/FH0G7NDNL(0~9)2/FH2G7NDNL(0~9)2]
6.5kg :[FH0G7WDNL(0~9)2/FH0G6WDNL(0~9)2]
7.0kg :[FH2G6HDNL(0~9)2]
leg
Adjustable
Lower cover
Door
Drawer
(For detergent and
fabric softener)
Power Plug
Control Panel
Drum
Drain Pump Filter
Drain Plug
Lower Cover Cap
If the supply cord is damaged,
it must be replaced by the
manufacturer or its service agents
or a similarly qualified person in
order to avoid a hazard.
100-1000kPa (1.0-10kgf/cm )
2
FH0G7WDNL(0~9)2/FH0G6WDNL(0~9)2]

5
Packing Support
carpeted floor.subjected
in caused
Unpacking
Cut the straps and open the upper flaps of Packing box & take out the Anti Rat Cover.
While taking out the Machine from packing,please take due care in removing packing
support given at centre of the base packing.
Anti Rat Cover is
placed below the upper
flaps of the Packing
box.
Anti Rat Cover installation
Accessories for fixing Anti Rat Cover.
1.Take out the poly bag (containing Screws/Washers).
2.Tilt the machine sideways.
3.Bend & insert the flaps of Anti Rat Cover into the bottom side of machine.
4.Assemble the Anti Rat Cover on the bottom side of the machine by using
Screws & Washers.
Machine.

6
adjustable legs
It is advisable to avoid, the usage of trolley & the movement of Washing Machine after installation.
As it may disturb the levelling of washer, which can create excessive noise & vibration.

Part can be different according to different models.
(1.0~10kgf/cm²)
Centre

Two rubber seals are provided
with inlet hose connectors.
These are used to prevent water
leakage.
Make sure the connection to tap
is sufficiently tight.
Check rubber seals in inlet hose
connectors. Screw the hose connector onto water supply tap.
Hose
Connector
Rubber
seal

Break
PE Bags
getting wet
getting wet
/leakage