6
Heat Pump Water Heater - 60 Hz (R134a)
4. Function List
Note
• These functions must be applied according to the model. Please refer to the follow ing function list for each model.
•¹ : This function can be operated only w hen the w ired remote controller is connected. The applicability of each function depends on the above table.
• ² : Optional accessories must be purchased separately. If show n as "Embedded", this function is included in product.
• The function Wi-Fi is only compatible w ith 2.4 GHz band. (802.11 b/g/n)
• Some specifications may be changed w ithout notifications due to our policy of innovation.
Category Function Description
Capture dust particles over 10μm in size and finer bacteria.
Reliability Self-diagnostic for product protection.
De-ice Control (Defrost) In the heating mode, de-icing of the outdoor heat exchanger automatically.
Individual
Control Wired Remote Controller ² -
Handheld Wireless Controller -
CAC
Network
Function
General Central Controller (Non LGAP) -
Network Solution (LGAP) -
Dry Contact ² -
PDI (Power Distribution Indicator) ² -
Outdoor Unit PI 485 ² -
Special
Function
Kit
Wi-Fi ² Easily access and control an air conditioner's functions from anywhere.
Water Level Sensor Connection ² Detect the water level in drain pan.
Crank Case Heater Pre-heating the compressor during winter.
Smart Inv erter Monitoring System (SIMs)² Help you to easily monitor, diagnose the air conditioner and get a quick resolution.
Others
This mode minimizes power consumption by using only heat pump for heating.
This mode provides relatively low power consumption and high recovery.
This mode primary uses heat pump for heating.
This mode is factory set mode for shipping.
If power is resupplied after blackout, product restart automatically.
If there is a temperature difference between room temperature and desired temperature,
you can use this function in other to prevent insufficient cooling and insufficient heating.
If there is a temperature difference between room temperature and desired
temperature, you can use this function in other to prevent over-heating.
Set the brightness of the display on the indoor unit.
Two Thermistor Control ¹
Overheating Protection
Convenience
Auto Restart Operation
HeatPump
Auto
Turbo
Vacation
Schedule
This mode provides the highest recovery.
This mode uses heat pump and heating element simultaneously.
This feature is recommended when the water heater is not in used for an extended
period of time.
In this mode, tank temperature will be maintained at about 68°F to minimize energy
consumption and prevent the water heater from freezing.
The Custormer can set up the operation time and mode based on their Demand Condition.
-
Indoor Unit Display Type
Indoor Unit Display Light
Temperature Control Basic cycle control method.
Air
Purifying Prefilter (Washable / Anti-Bacteria)
Self Diagnosis
The air conditioner which DRED is available is capable of DRM1,DRM2 and DRM3 and complies with standard AS/NZS 4755.3.1.
•
