Liden S29B User manual

Bench scale
USER MANUAL
S29B
www.liden-weighing.com

- 2 -
Introduction
The S29 series weighing scales is fully water proof scale.
It is suitable for sanitary applications and general weighing.
IP65 waterproof technology
Stainless steel housing.
Super low power consumption.
Optional options for dry cell battery and rechargeable battery.
Large 25mm LCD with white LED back light display.
CAUTION
Below the scale there is a breathable knob. Its default setting is for weigh. If you
want to wash tighten the knob, after wash release the knob for weigh
When want to weigh,
release screw for getting
normal pressure
When want to wash, tight
screw for getting seal

- 3 -
Installation
•Place the scale on a table.
•Connect the adaptor pin in to the indicator adaptor jack.
Adaptor jack is locating, rear side of the scale.
•Adaptor connects into your AC power socket. Pluggable equipment must
be installed near an easily accessible socket outlet with a protective
ground/ earth contact.
•Turn on the On/Off key. If you want to turn off, press the key again.
•Display will be show the version number and will be starting self checking.
•After self checking, display will be come to normal weighing mode.
•Warm-up time of 15 minutes stabilizes the measured values after switching
on.
•Calibrate with exact calibration weights, minimum 1/3 of the scale capacity
want to use for calibration. For calibration see details in parameter.
Then you can start your operation

- 4 -
Operation
Initial Start-up
Warm-up time of 15 minutes stabilizes the measured values after switching on.
1. Power ON/OFF
Switch on the scale by pressing . The display is switched on and the
self test is started.
If you want to switch off press the key again.
2. Zero
Environmental conditions can lead to the balance exactly zero in spite
of the pan not taking any strain. However, you can set the display of
your balance to zero any time by pressing key and therefore
ensure that the weighing starts at zero.
3. Tare
The weight of any container can be tared by pressing the button so
that with subsequent weighing the net weight of the object being weighed
is always displayed.
•Load weight on the pan.
•Press key. Zero is displayed, and tare is subtracted.
•Remove weight from the platform. Tared weight is displayed. It can
set only one tare value. It can display with a minus value.
•Press key. Zero is displayed, tare weight is cleared.
4. Unit
Press both keys in the weighing mode to change the
weighing unit kg / g
5. Backlight
Press key three seconds, display will show “BK-AU”, Press to
select backlight AU/OF, then press key to confirm.