by
FOR LIGHT EFFICIENT DESIGN PRODUCT INFO CALL • 188 S. Northwest Highway •Cary, IL 60013 • 847.380.3540 •led-llc.com
FOR REMPHOS PRODUCT INFO CALL • 30 Log Bridge Road, Building 200 •Middleton, MA 01949 •877.997.3674 •remphos.com
12.05.18 Information is subject to change without notice.
ON/OFF will memorize the last mode set
before turning off
The primary LED module will automatically
turn on at dusk and remain at 50% brightness
when the motion sensor is disabled. After 5
hours or when the battery capacity is below
30%, the fixture will switch to Mode .
When motion is detected (within 24ft), the
secondary LED module will turn off and the
primary LED module will turn on to full
brightness (700LM). After 20 seconds of no
motion, the primary LED module will turn off
(to conserve battery). The secondary LED
module will then turn back on.
The primary LED module will turn on to full
brightness (700LM) when motion is detected
in the range of 24ft. Once no motion is
detected for 20 seconds, the fixture will turn
off. The secondary LED module will not turn
on in this mode.
The fixture features a unique optical design to provide safe illumination of the area while
maximizing battery life. The illumination is made up of a primary and a secondary LED
module. The secondary LED module provides a low light level.
Remind:When switching to a different working mode,the lamp will flash one time, which
is normal and indicate that the working mode is changed successfully.
by
FOR LIGHT EFFICIENT DESIGN PRODUCT INFO CALL • 188 S. Northwest Highway •Cary, IL 60013 • 847.380.3540 •led-llc.com
FOR REMPHOS PRODUCT INFO CALL • 30 Log Bridge Road, Building 200 •Middleton, MA 01949 •877.997.3674 •remphos.com
12.05.18 Information is subject to change without notice.
. Please
note the arrow icon on the plate is
upward before fix the screw.
5
5
2.36
2.56
.
.
1. .
.
. 42 .
2.
.
3. .
4. .
5. .
.
6.
.
7.
8. .
Loosen the
screws on the
both sides of
the lamp
Remove the screws on the
side of the mounting plate.
Please press any button on the lamp
to activate the lamp and remote
.
.
.
