Light-Point SPIRIT F1 User manual

SPIRIT
F1 & T1
User instructions
LIGHT-POINT.COM
The balance between tubular structures gives
the SPIRIT collection a distinctive three-
dimensional expression. To enhance the experience
of its ultramodern appearance, we chose to
introduce the collection in Rose Gold/Black and
Titanium/Black.
SPIRIT
Collection
LIGHT-POINT.COM

International warranty
Your produc t has gone through rigorous testing in order to live up to
the highest quality standards. It therefore carries a 7-year warranty
from the date of the original retail purchase receipt, covering defects
in materials and workmanship when used normally in accordance with
the published LIGHT-POINT guidelines.
These guidelines include but are not limited to information contained
in technical specications, safety instructions and quick start guides.
LIGHT-POINT is not responsible for damage arising from failure to
follow instructions relating to the use of the product.
LIGHT-POINT is a registered trademark of NORDIC LIVING GROUP.
For more information, please visit
LIG H T-P OIN T.COM
General use
·The product is designed for indoor and outdoor use*.
*Rose Gold is not recommended for outdoor use.
·The lamp gets hot after prolonged use, therefore, do not cover the
product.
Cleaning instructions
·Before cleaning, ensure that the power supply is switched off.
·Wipe surface of lamp shade with a soft cloth.
·Do not use any abrasive cleaning tools such as steel wool, scouring
sponges or stiff brushes.
·Never use strong cleaning agents such as white spirit, household
glass cleaner or cellulose thinners.
Safety precautions
·The appliance should be installed, connected and tested by
·Turn off the power supply before installation or maintenance
of the lamp, and make sure that the cables are not squeezed or
damaged by sharp edges during installation.
·The lamp should not be covered by insulation blankets or similar
materials.
Installation instructions
1Before installing, make sure the power supply is switched off.
2
3
AFix the tube to the base using the supplied screws.
BSecure the cable using the cable restrainer by tightening
the two screws.
C1. Connect the cables.
2. Insert the plug into the socket.
D- Turn on or turn off the lamp by moving your hand in front of the sensor.
- Adjust luminous intensity by keeping your hand still in front of the sensor.
Please note: Before removing the plug from the socket, switch off the lamp.
After nishing every step, tighten the screws, have the xture xed,
and then connect the power supply.
C
C
A
2-8cm
B
D
SPIRIT T1SPIRIT F1
L+
–
DRIVER
N
The product is designed for indoor use only.
The lamp gets hot after prolonged use, therefore, do
not cover the product.
NOTE: The ceiling/lamp base
can be used as installation box.