Lighting Science Healthe Cleanse Installation and user guide

HEALTHE BY LIGHTING SCIENCE |3905 W EAU GALLIE BLVD, SUITE 101, MELBOURNE, FL 32941 |877.999.5742 |HEALTHELIGHTING.COM
Cleanse TrofferCleanse Troffer
Service and Maintenance GuideService and Maintenance Guide
Routine maintenance to key components of the Cleanse Retrot Troffer will help to sustain
peak performance and minimize downtime. For optimal performance, HEPA/Charcoal lter
should be inspected monthly and is recommended to be replaced every six months. For
UV LED, it is recommended to replace after every 2,000 hours of service as indicated by a
solid yellow indicator light on the Troffer.

HEALTHE BY LIGHTING SCIENCE |3905 W EAU GALLIE BLVD, SUITE 101, MELBOURNE, FL 32941 |877.999.5742 |HEALTHELIGHTING.COM
Replacing the HEPA/Charcoal Filter in Cleanse Troffer
1. Turn off the Cleanse Troffer via the switch on the front (Fig 1).
2. Locate the screen closest to the power switch. Remove the
two screws and the screen (Fig 2).
3. Once the screen is removed, bend the tabs on the side of
the lter to release and remove it (Fig 3).
4. Install new lter.
5. Reinstall screen with the corresponding 2 screws (Fig 2).
6. Turn on the power via the switch on the front of the unit
(Fig 1).
Replacing the UV LED Sanitization Module in Cleanse Troffer
1. Turn off the Cleanse Troffer via the switch on the front (Fig 1).
2. Identify the two slots on the edge of the Troffer next to
the screens. With a hand on the Troffer, insert a at head
screwdriver into the slot to trigger the latch release (Fig 4).
3. Once released, carefully let the Troffer swing down on its
hinges for about 8 inches while supported by two safety
cables (Fig 5).
4. Detach the two links connecting the safety cable to the
Troffer and carefully let the Troffer swing down the rest of
the way on its hinges (Fig 5 A/B).
5. Disconnect the quick connect of the UV LED module and
remove the six screws to release the metal cover exposing
the UV LED module behind it (Fig 6).
6. Remove existing UV LED module and install the new UV
LED onto the metal cover using included double-side tape.
7. Attach metal cover to Troffer with the six corresponding
screws and connect the quick connect (Fig 6).
8. Swing Troffer back towards housing to reattach the safety
cable links (Fig 5, 5A/B).
9. Once the safety cables are attached, push Troffer back into
housing until a "CLICK" is heard, indicating the Troffer is
fully reinstalled and secured.
10. Turn on the power using the switch on the front of the unit
(Fig 1).
Fig 1
Fig 3
Fig 5
Fig 2
Fig 4
Fig 6
5A
5B