Like It The Container Store 6-Section Shoe / Accessory... User manual

Assembly Instructions
Step-3A - If using partitions as back panels.
Step-1
When assembling a base, insert the connectors into the two main boards and three side boards.
The ridged side should be facing upward.
Step-2
2 cubbies
Boot
For Boot Storage:
Follow the instructions on the back.
By excluding the main board
in the middle, the 2 cubbies
become Boot Storage.
Shoe / Accessory
Grid
-Section6
Base
Ridged side
Main board
Side board
Connector
Repeat Step-1 to complete the 6-Section Shoe / Accessory Grid.
Note: If using this product for Boot Storage, skip to the next page.
Base
Partition
Ridged side
Insert the partition
to the end.
Supply units
Main board × 8 Side board × 9 Partition × 6 Connector × 24
The ridged side should
be facing upward.
①Flip the grid over and
insert 3 connectors
as shown below.
②Place the partition into
the slot of the main board
as the back panel.
④Insert the remaining
9 connectors.
③Repeat ②to finish inserting
the remaining 5 back panels.

For Boot Storage
The Shoe / Accessory Grid can be expanded in Vertical and Horizontal combinations.
Remove all items out of the cubbies before expanding.
How to expand
Remove all items and lay the Shoe / Accessory Grid down the same as when assembling.
Remove the connectors at the desired extension points.
Snap the extension main and side boards and insert the connectors.
①
②
③
Step-3B – If using partitions on interior of grid.
Place the partition into the 2 holes in the middle of the main board.
①To create Boot Storage, do not install
the main board between 2 cubbies.
④Insert the 2 remaining connectors.
②Flip the grid over and insert the 10 connectors
into the main and the side boards.
Use the 2 cubbies from the bottom
when creating Boot Storage.
2 cubbies
Boot
For easy assembly,
position the partition
at an angle then
turn it upright.
Partition
Ridged side
Base
Ridged side
Do not insert the
connectors yet.
Custom Configuration (with additional 3 or 6-Section Shoe / Accessory Grids; or Vertical and / or Horizontal Add On Kits – sold separately)
③Position 2 partitions as back panels.
Insert the partition
to the end.