Like It The Container Store User manual

Assembly Instructions
Step-3A - If using partitions as back panels.
Partition
Step-1
Ridged side
Base
When assembling a base, insert the connectors into the main board and two side boards.
The ridged side should be facing upward.
Main board
Side board
Connector
Step-2
Repeat Step-1 to complete the 3-Section Shoe / Accessory Grid.
※ Note: If using this product for Boot Storage, skip to the next page.
①Flip the grid over and
insert 2 connectors
as shown below.
②Place the partition into
the slot of the main board
as the back panel.
④Insert the remaining
6 connectors.
Ridged side
Base
2 cubbies
Boot
For Boot Storage:
Follow the instructions on the back.
By excluding the main board
in the middle, the 2 cubbies
become Boot Storage.
Shoe / Accessory
Grid
-Section3
Insert the partition
to the end.
Supply unitsSupply units
Main board × 4 Side board × 6 Partition × 3 Connector × 16
The ridged side should
be facing upward.
③Repeat ②to finish inserting
the remaining 2 back panels.

Base
For easy assembly,
position the partition at an angle
then turn it upright.
Partition
For Boot Storage
The Shoe / Accessory Grid can be expanded in Vertical and Horizontal combinations.
Remove all items out of the cubbies before expanding.
How to expand
Remove all items and lay the Shoe / Accessory Grid down the same as when assembling.
Remove the connectors at the desired extension points.
Snap the extension main and side boards and insert the connectors.
①
②
③
Ridged side
Step-3B – If using partitions on interior of grid.
Place the partition into the 2 holes in the middle of the main board.
①To create Boot Storage, do not install
the main board between 2 cubbies.
③Position 2 partitions as back panels. ④Insert the 2 remaining connectors.
②Flip the grid over and insert the 6 connectors
into the main and the side boards.
Do not insert the
connectors yet.
Use the 2 cubbies from the bottom
when creating Boot Storage.
2 cubbies
Boot
Ridged side
Custom Configuration (with additional 3 or 6-Section Shoe / Accessory Grids; or Vertical and / or Horizontal Add On Kits – sold separately)
Insert the partition
to the end.