LINCAST CS-RP1 User manual

The CS-RP1 Repeater
The use of a REPEATER is to allow the operation of a portable traffic light system where clear line
of sight is not possible. This may arise when road works are carried out in hilly terrain or where
the road curves around the side of a hill.
NOTE
Repeaters can ONLY be added to a SHUTTLE and 2 WAY configuration
Only ONE repeater can be added to a system
CS-TRH4 wireless remotes must be synchronised to U1 before U1 is synchronised to the
Repeater
Note: The REPEATER must be synchronised last.

To configure:
Obtain two CS-400 controllers and one CS-RP1 REPEATER (and a CS-TRH4 radio remote if it is
to be used).
Select SHUTTLE configuration on U1 and U2 and synchronise the CS-400s controllers.
Synchronise the CS-TRH4 remote.
Check the CS-TRH4 can communicate with U1.
After all the previous steps, now synchronise U1 to the REPEATER:
Press the SYNC button on U1 for 5 seconds. U1’s screen will show:
Press the SYNC button on the REPEATER.
When synchronised, the HOME screen on U1 will show:
Note the word REPEATER in square brackets. This shows U1 and U2 are communicating via the
REPEATER.
Note: Only U1 is required to be synchronised to the REPEATER.
U2 will synchronise to the REPEATER automatically.
Various connectivity screens will show on the REPEATER until the following main HOME screen is
reached:
This shows U1 and U2 are being received (OK), the REPEATER is receiving (RX) and transmitting
(TX) data. The detected supply voltage is 13.4V.

Placement of Controllers:
Position the REPEATER at the top of the hill or on the corner of a bend so that both U1 and U2
have clear line of site of the REPEATER and turn on.
Position U1 & U2 at either end of the road works and turn on.
All modes are available in this configuration
Flash Yellow
Manual
Auto
Vehicle Sensor
The system can be controlled at either U1or U2
NOTE: Due to continuous product improvement, the screen simulations in this guide may not
reflect actual product.
PROUDLY MANUFACTURED & SERVICED BY
LINCAST INTERNATIONAL PTY LTD
2/3 SIR LAURENCE DVE
SEAFORD 3198
VICTORIA
AUSTRALIA
Ph: 03 9776 4442
www.lincast.com.au [email protected]