Lincat D3H Owner's manual

IS 282 ECN 3607 Page 1 of 8
Installation, Operating and Servicing
Instructions
Seal Heated Merchandisers
C6H, D3H and D5H –all models
Please make a note of your product details for
future use:
Date Purchased:_________________________
Model Number:__________________________
Serial Number:__________________________
Dealer:_________________________________
_______________________________________

IS 282 ECN 3607 Page 2 of 8
CONTENTS
Important Information
2
Warnings and Precautions
3
Technical Data
3
Checklist of Enclosures
3
Installation and Commissioning
3-4
Operating Instructions
5-6
Cleaning
6-7
Servicing, Maintenance and Component Replacement
7
Fault Finding
7
Spare Parts List
7
Service Information and Guarantee
8
IMPORTANT INFORMATION
Read these instructions carefully before using this product, paying particular
attention to all sections that carry warning symbols, caution symbols and notices.
Ensure that these are understood at all times.
WARNING!
This symbol is used whenever there is a risk of personal injury.
CAUTION!
This symbol is used whenever there is a risk of damaging your Lincat product.
NOTE:
This symbol is used to provide additional information, hints and tips.
KEEP THIS MANUAL FOR FUTURE REFERENCE

IS 282 ECN 3607 Page 3 of 8
WARNINGS AND PRECAUTIONS
This appliance must be Installed, Commissioned and Serviced by a qualified
person in accordance with national and local regulations in force in the country of
installation.
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified person.
Ensure that the plug/socket is accessible at all times.
Strip plastic coating and clean the appliance before use.
During operation parts may become hot - avoid accidental contact.
Disconnect this appliance before servicing, maintenance or cleaning.
TECHNICAL DATA
D3H/75
D5H/75
D5H/100
C6H/75
C6H/100
Volume (l)
113.0
163.0
220.0
284.0
380.0
Width (mm)
750
750
1000
750
1000
Depth (mm)
350
500
500
650
650
Height (mm)
575
575
575
755
755
Weight (kg)
34.0
43.0
55.0
57.0
71.0
Power rating (kW)
0.8
1.5
2.0
1.5
2.0
CHECK LIST OF ENCLOSURES
Warranty card
Instructions manual
Shelves
Base plate(s)
Crumb tray
Water bath and lid
3mm Allen key
INSTALLATION AND COMMISSIONING
This appliance must be earthed.

IS 282 ECN 3607 Page 4 of 8
An equipotential bonding terminal is provided to allow cross bonding with other
equipment.
If replacing the plug connect the terminals as follows:
Green and Yellow wire Earth E
Blue wire Neutral N
Brown wire Live L
Supply cords shall be oil resistant, sheathed flexible cable not lighter than ordinary
polychloroprene or equivalent elastomer sheathed cord (code 60245 IEC 57)
Install this appliance on a level surface ensuring all vents are unobstructed. Any
partitions, walls or furniture must be of non-combustible material. Minimum
distances A 100mm B 500mm –see Fig 1.
Fig 1

IS 282 ECN 3607 Page 5 of 8
OPERATING INSTRUCTIONS
Only qualified or trained personnel should use this appliance.
This appliance relies on the circulation of warm air passing through and around the
shelves. Ensure circulation is not obstruct by overloading product or by using
aluminium foil.
This appliance is intended for displaying pre-heated food –not for heating
food.
Fig 2
Identification (Fig 2)
1. Cable 2. On/Off switch 3. Light switch 4. Temperature controller 5. Crumb tray
/ Water bath
Ensure the base plates lie flat within the base and the shelves are secure. Close all
doors –front and rear. Connect to the electricity supply, switch on the light (3) then
switch on the ‘On/Off’ switch (2). C6 appliances are factory set to 85 Deg C. Press
and hold the ‘Set’ button to confirm this.