Linptech G4 User manual

Remove the transmitter
3M3M
3M 3M
3M3M
3M3M
3M3M
3M3M
3M
3M
V1.1
USER'S MANUAL
STEP 1: Plug the receiver into the socket
Aenon : Please place the receiver at least 20 in, above the ground
to maximize signal strength.
Quick and Easy Setup Install the transmitter
SELF-POWERED WIRELESS DOORBELL G4
Short press to change volume.
There are 5 levels of volume in total
including the ‘Mute Mode’
The chosen volume will be stored and
the receiver will keep the volume even
if it is powered off and power on again.
Attention: The music coded with the
transmitter is set during the course of
coding. When you change the music by
pressing the music key in ordinary time,
the music coded with the transmitter
will not be changed.
STEP 2: Enjoy it
Opon 1
Opon 2
If the wall is clean and plat enough, tape is enough for installaon.
If the surface of the wall is not good enough, use way 2 for installaon
Press the transmitter and the
music will ring and light will
flash with the music.
paste the 3M double-sided tape
on the back of the transmier.
Paste the other side of the
double-sided tape on the wall.
Remove the mounng panel from
the transmier using screwdriver.
Fix the transmier
to the panel.
You can remove the transmier from the panel when necessary.
Plug the straight screwdriver into the mouth of the transmier
then turn it 90°,and the transmier will be separated from
the mounng panel on the wall.
The receiver will ring and the instruction lights will flash.
90°
fix the mounng
panel to the wall.
Install the transmitter
Volume key:
90°
Music key:
Short to change music.
16 songs are available.

Repeat pressing the music key
to choose music until you find your favorite music.
Press the volume key or the music key constantly for at least 3
seconds, the light will flash. (It shows that the receiver has entered into
the coding mode and it is waiting for your pressing the transmitter.)
Till now, you can release the key of the receiver.
The 1st step:
Choose the music.
The 2nd step:
Enter coding
model
The 3rd step:
Just press the
transmier.
The coding has been done before the doorbell out of the factory. You can use it directly without
coding. Coding is needed only when you add transmier or change transmier. Through coding,
one transmier can match with several receivers or several transmiers can match one receiver.
83mm*48mm*23.5mm
59
At this time:
if you still need to change music, you can press the music key to change music.
If you want to quit the coding course, you can press the volume key.
If no action is done within 30 seconds, the receiver will quit the mode of coding.
At this time, the music that has been chosen by you will ring,
it means successful coding.
After this, when you press the transmitter, the music that has been
chosen by you will ring . Every time you press the transmitter , the
music will be the same one, even after sudden power-off.
Press the music key or the volume key constantly at least seconds, until the light flashes times. 10 4
All the transmitters connected with the receiver will be removed. At this time, if you press the
transmitter, the receiver will not react.
83mm*46mm*20mm
45
About us
consumpon
enjoy
consumpon
~
Output power
Dimension
Dimension
~