LINX-LIFT LBC Series User manual

USER MANUAL
LBC SERIES
BEAM CLAMP
(EN 13155)
This equipment should not be installed, operated or maintained
by any person who has not read and understood all the contents
of this manual. Failure to read and comply with the contents of
this manual may result in serious bodily injury or death and/or
damage to property.
WARNING!
January 2021

1. GENERAL
This user manual provides important information for all personnel involved with the safe installation, operation
and proper maintenance of this product.
When using beam clamps there are different kinds of risks that you may encounter which could result in
personal injury or damage to property. It is therefore imperrative that anyone involved in the installation,
maintenance or operation of the beam clamp is familiar with the contents of this user manual and follows the
guidance set out in it.
2. SAFE OPERATION INSTRUCTIONS
1. The beam clamp should be inspected for wear or damage prior to assembly and installation.
2. NEVER use a beam clamp that is found to be defective in any way.
3. Only ever attach a hoist with a rated capacity equal to or less than the capacity of the beam clamp.
4. Ensure that the beam clamp is situated correctly over the centre of gravity of the item being lifted.
5. Do not subject the beam clamp so side loading.
6. Never lift a load over people!
7. Do not swing a suspended load.
8. Always ensure that that the beam clamp is properly tightened and that the lifting appliance is fitted
correctly to the eye of the beam clamp.
9. Do not modify the beam clamp in any way.
3. TECHNICAL SPECIFICATION
Model LBC-1T LBC-2T LBC-3T LBC-5T LBC-10T
Capacity (t) 1 2 3 5 10
Beam flange width (mm) 75-230 75-230 80-320 90-310 90-320
Dimensions (mm)
A max 270 270 350 350 365
B min 185 185 225 225 255
B max 370 370 500 500 510
C 80 85 117 125 158
D 5 6 8 10 12
E 220 220 265 265 280
F min 90 90 140 140 170
F max 165 165 225 225 235
G min 25 25 45 45 50
Weight (kg) 3.8 5 9 11 18.6

4. EXPLODED VIEW DRAWING
1Handle 5 Screw mandrel
2 Side plate 6 Socket head cap screw
3 Shackle 7 Lever handle link cover
4 Stay
5. INSTALLATION
1. Measure the width of the beam flange and open up the beam clamp accordingly.
2. Place the beam clamp on to the beam flange and turn the threaded load bar using the handle to reduce
the width until it clamps tightly on the beam.
6. MAINTENANCE
1. Check the general condition of the beam clamp prior to use.
2. In the event that any defective parts are found, remove the beam clamp from service immediately.
3. Defective parts should be replaced with genuine items only.