Lionel Exploding User manual

Lionel
Exploding
Ammunition Dump
Owner’s Manual
72-4233-250
5/08

Assembling and operating the Exploding Ammunition Dump
Congratulations
2
Set the ammunition dump and it will explode with a direct hit from a missile.
Keep clear of the ammunition dump when the trigger is set. Beware of flying
parts and the snapping mousetrap mechanism.
1. Position the stamped metal base on your layout. To prevent movement of the base, you
may choose to drive two screws through the holes in the base.
2. Bring the spring-loaded arm forward (toward the “B” end of the base), locking it in place
with the trigger mechanism. Refer to Figure 1 on page 3.
Keep your fingers clear of the spring-loaded arm.
3. Slide in the trigger lock. The trigger lock will prevent the mechanism from tripping as you
assemble the structure on the base.
4. Position the larger roof/side panel at the “A” end of the base. Be sure that edge of the base
should fit between the tabs on the panel.
5. Position the other side panel at the “B” end of the base in the same manner.
6. Position the two trapezoidal end panels next to the base. The trigger lock will extend
through the slot in one of the sides. Be sure that the tabs on the roof fit into the end
panels.
To explode the structure, carefully pull out the trigger lock and stand clear. Fire a missile at
the ammunition dump and it will fly into pieces!
Caution!
Caution!
Congratulations on your purchase of the Lionel Exploding Ammunition Dump! This accessory consists of a stamped metal base with a “mousetrap” trigger mechanism and
four building parts.
The following Lionel marks may be used throughout this instruction manual and are protected under law. All
rights reserved.
Lionel®, TrainMaster®, Odyssey®, RailSounds®, CrewTalk™, TowerCom™, DynaChuff™,
StationSounds™, Pullmor®, ElectroCoupler™, Magne-Traction®, CAB-1®Remote Controller,
PowerMaster®, Lionel ZW®, ZW®, PowerHouse®, TMCC®, Lionelville™, Lockon®, Wireless Tether™,
LionMaster®, FatBoy™, American Flyer®, TrainSounds™, PowerMax™, LEGACY™, PowerMax™Plus
The name FasTrack®is used with permission from Pitsco, Inc.

3
Assembling and operating the Exploding Ammunition Dump
(continued)
Operating the Exploding Ammunition Dump
Figure 1. Ammunition dump assembly

Limited Warranty/Lionel Service
This Lionel product, including all mechanical and electrical components, moving parts, motors and structural
components, except for light bulbs, is warranted to the original consumer-purchaser, for one year against
original defects in materials or workmanship when purchased through an authorized Lionel merchant.
This warranty does NOT cover normal wear and tear, light bulbs, defects appearing in the course of commercial
use, or damage resulting from abuse or misuse of the product by the purchaser. Transfer of this product by the
original consumer-purchaser to another person voids this warranty. Modification of this product voids this warranty.
Any warranted product which is defective in original materials or workmanship and is delivered by the original
consumer-purchaser to Lionel L.L.C. or an authorized Lionel L.L.C. Service Center, together with proof of original
purchase will, at the option of Lionel L.L.C., be repaired or replaced, without charge for parts or labor. In the event
the defective product cannot be repaired, and a replacement is not available, a refund of the original purchase
price will be granted. Any products on which warranty service is sought must be sent freight or postage prepaid, as
transportation and shipping charges are not covered by the warranty.
In no event shall Lionel L.L.C. be liable for incidental or consequential damages.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above
exclusion may not apply to you.
This limited warranty gives you specific legal rights, and you may have other rights which vary from state to
state.
Instructions for Obtaining Service
If service for this Lionel L.L.C. product is required, bring the item, along with your dated sales receipt and
completed warranty information to the nearest Authorized Lionel Service Center. Your nearest Lionel Service Center
can be found by calling 1-800-4-Lionel, or by accessing our Website at www.lionel.com.
If you prefer to send your product back to Lionel L.L.C. for repair in Michigan, you must first call
586-949-4100 or FAX [phone], or write to Customer Service, P.O. Box 748, New Baltimore, MI
48047-0748, stating what the item is, when it was purchased and what seems to be the problem. You will be sent a
return authorization letter and label to ensure your merchandise will be properly handled upon receipt.
Once you have received your return authorization and label, make sure that the item is packed to prevent
damage during shipping and handling. We suggest that you use the product’s original packaging. This shipment
must be prepaid and we recommend that it be insured.
Please make sure you have followed all of the above instructions carefully before returning any merchandise
for service. You may choose to have your product repaired by one of our Authorized Lionel Service Centers after its
warranty has expired. A reasonable service fee will be charged.
Warranty Information
Please complete the information below and keep it, along with your dated sales receipt. You must present this
and your dated sales receipt when requesting warranty service.
Name�����������������������������������������������������������������������
Address ����������������������������������������������������������������������
Place of Purchase ���������������������������������������������������������������
Date of Purchase����������������������������������������������������������������
Product Number ����������������������������������������������������������������
Product Description ��������������������������������������������������������������
©2008 LIONEL L.L.C., CHESTERFIELD, MI 48051-2493
UNITED STATES OF AMERICA
PRINTED IN CHINA