Living Well MWBLND01 User manual

INSTRUCTION MANUAL
Read entire manual before operating this product.
Use only as directed.
LIVINGWELL
MONTEL
WITH
TM
1200W EMULSIFIER BLENDER

Living Well Products LLC promotes Montel Williams’ message of living well
physically, emotionally, and spiritually. Our goal is to make healthy living
simple, convenient, and accessible to everyone by oering quality products
at a great value. We strive to make “Living Well” a simple, easy, and aordable
daily choice for our family of consumers.
MONTEL WILLIAMS
Congratulations! Creating healthy smoothies, shakes, and more is
as simple as pushing a button with the 1200W Emulsier/Blender.
Living a healthy lifestyle just got a lot easier and faster!
INTRODUCTION

• Read all the instructions and warnings
completely before operation. Keep the
instructions for future reference.
• Not intended to be used by children.
Close supervision is necessary when any
appliance is used near children.
• Keep unit unplugged when not in use,
when removing or putting on parts, and
when cleaning.
• Take precaution to not let the cord hang
over the edge of a counter or table or
come into contact with a hot surface.
• Only operate Blender with Lid, Lid Plug, and
Pitcher securely on.
• Plunger should only be used when Blender
is assembled correctly.
• Blades are sharp. Handle with extreme
care to ensure there are no injuries.
• Do not put ngers, hands, or any utensil or
tool near Blades when in motion or when
they are slowing to a stop. Injury to yourself
and damage to the unit will occur.
• It is recommended to use a rubber spatula/
scraper if needed once the Blades have
come to a complete stop and the unit has
been turned o and unplugged.
• Do not submerge the Blender Base or
electrical cord in water. Electrical shock
will occur and cause damage and injury to
yourself, surrounding areas, and unit.
• If product is damaged, contact customer
service. Only operate unit if it is in proper
working condition. Do not operate if
dropped, has cord damage, damaged
Blades, or is malfunctioning.
• The use of accessory attachments
not recommended by the appliance
manufacturer may result in re, electric
shock, or personal injury.
• Do not disassemble or reconstruct Base,
Blades, or any parts of the Blender. This
may cause personal injury, damage to the
unit and its surroundings, and make the
warranty void.
• Do not over blend your ingredients. This
can cause overheating and damage to
the unit. Use extreme attention to this when
creating nut-butters or oil-based foods.
• Use caution when using hot liquids and
ingredients. Escaping steam and spraying/
splashing of liquid may occur. Fill liquids
below max line and begin blending at
slowest speed. It is recommended to keep
hands away from Lid when in use and
to use oven mitt or potholder to prevent
possible burns. Keep all exposed skin away
from hot liquids and ingredients when
being used in the Blender.
• Blender is intended for indoor, household
use only. It is not intended to be used
outdoors or for commercial use.
• Do not leave unattended when operating.
• Electrical Shock Hazard Warning:
◊ Use grounded outlet only
◊ Do not use adapter, remove
ground, or use an extension cord
◊ Failure to follow instructions
can cause death or
electrical shock
WARNINGS
SPECIFICATIONS
Model 1200W Emulsier/Blender
Weight 3.46kgs (7.6lbs)
Materials Stainless Steel, ABS, Steel, PC,
Silicone

UNIT DIAGRAM
1.Pitcher Lid
2.Lid Plug
3.Pitcher
4.Blender Base
5.Plunger
6.20oz Personal Cup
7.Personal Cup Blade Base
8.Personal Cup Lid
1
3
4
5
6
7
8
2

Using Your 1200W Emulsier/Blender:
Before using your Blender, follow the Cleaning Guidelines and read the
Instruction Manual (including all warnings) completely.
Remove all packing material from all parts of the Blender before assembling.
To Assemble Your Blender:
Place Base on at, stable surface that is not near water or extreme heat.
For Pitcher
• Securely put the Pitcher onto the Base. The Base has a peg in each corner
that ts into the corner of the Pitcher. Line these up and press Pitcher into
Base. You should hear a click to know it is secure.
◊ The Base of the Blender has a Safety Lock. The Safety Lock is engaged
when the Pitcher is mounted properly. The Safety Lock will prevent
the Blender from functioning if not properly assembled.
• Push the Lid Plug into the opening in the Lid. It ts securely and should not
be loose.
• Place ingredients inside Pitcher and close the Lid and Lid Plug tightly.
• Push the Lid into the Pitcher. The Lid should t securely. You should feel the
suction as you are putting the Lid onto the Pitcher.
For Personal Cup
• Fill Personal Cup with desired ingredients. Do not ll past the MAX line.
• Screw the Personal Cup Blade onto the Personal Cup. Ensure it is tight and
on properly to prevent leaking.
• Once the Personal Cup Blade is securely on the Personal Cup, turn it over
so the Personal Cup Blade is at the bottom.
• Put the Personal Cup Blade with Personal Cup onto the Blender Base by rst
locating the orange triangle on the Personal Cup Blade and the Blender
Base. Align the triangles, and press the Personal Cup Blade into the Blender
Base. It is a snug t and ts securely if assembled properly.
◊ The Personal Cup Blade has a Safety Lock. The Safety Lock is
engaged when the Personal Cup Blade is mounted properly. The Safety
Lock will prevent the Blender from functioning if the triangles are not
aligned.
Final Assembly
• Once properly assembled, plug Blender in.
• Push the Power button to turn Blender on. The indicator light will light up.
• Select Correct Program Setting based on desired outcome (see below
section Choose the Correct Program Setting).
• When Program is nished the indicator light will ash. Select another
Program or aer 3 minutes the Blender will power o automatically.
Choose the Correct Program Setting:

• Single Serve – this program is specically designed to be used with the
included Personal Cup. It will run for 60 seconds and then automatically turn
o.
• Puree – Use this function to blend ingredients into a smooth, thick, soup-like
consistency. It will run for 60 seconds and then automatically turn o.
• Crush – Use this function to crush ice and frozen ingredients. It will run for 60
seconds and then automatically turn o.
• Soup – Use this function to create healthy soups from fresh ingredients. The
Blender will run for 7 minutes and then automatically turn o. Take caution
when using hot ingredients. Ensure Lid and Lid Plug are securely on to
prevent splashing. It is suggested to use a pot holder or oven mitt. If Blender
runs for full 7 minute cycle, allow time for the Blender to cool before running
again. This will prevent overheating.
• Smoothie/Clean – This button has 2 functions. Use to create healthy
smoothies from fresh ingredients or follow the Cleaning Guidelines. It will run
for 60 seconds and then automatically turn o.
• Power – This powers the Blender on and o.
• Low – This is a manual function. It is the lowest speed. Do not run for more
than 7 minutes. If used for the full 7 minutes, allow time for the Blender to
cool before running again. This will prevent overheating.
• Medium – This is a manual function. It is a medium speed. Do not run for
more than 7 minutes. If used for the full 7 minutes, allow time for the Blender
to cool before running again. This will prevent overheating.
• High – This is a manual function. It is the fastest speed. Do not run for more
than 7 minutes. If used for the full 7 minutes, allow time for the Blender to
cool before running again. This will prevent overheating.
• Pulse – This is a manual function. It is a fast speed. It will run for as long as you
hold the button down. Do not run for more than 7 minutes. If used for the
full 7 minutes, allow time for the Blender to cool before running again. This will
prevent overheating.
How To Use the Plunger:
• If the ingredients in your Blender are having a hard time circulating, using the
Plunger can help. Only use the Plunger that came with your Blender, do not
use anything else.
• The Plunger should be used in combination with the Blender Lid.
• Carefully remove the Lid Plug and insert the Plunger.
• The Pitcher cannot be more than 2/3 full when using the Plunger. Otherwise,
overow may occur. This may cause injury to you, the Blender, and
surrounding areas.
• Do not use the Plunger for more than 30 seconds at one time. Overusing the
Plunger may cause overheating.
• If using the Plunger straight down does not help to move the ingredients,
move it side to side. Do not force the Plunger to the bottom of the Pitcher.
This can cause injury to the Blender, Plunger, you, and the surrounding area.
Automatic Overload Protection:

The Blender is designed to automatically turn o if it begins to overheat. If this
occurs, follow these steps:
• Power o and unplug your Blender for at least 60 seconds to allow it time to
reset itself.
• If aer 60 seconds your Blender will not turn back on, power o and unplug
again. Remove Pitcher and use a blow dryer on cool setting to blow air into
the blade area and underneath the Base of your Blender.
Cleaning and Storing Blender:
Before using your 1200W Emulsier/Blender for the rst time, please follow
the Care and Cleaning Instructions below.
• Remove unit from packaging, discard any packing material, and
review all warnings and instruction manual in its entirety.
Cleaning Pitcher Lid,Pitcher Lid Plug,Personal Cup Lid, and Plunger:
• Separate the Lid Plug from the Lid.
• Wash all parts with warm, soapy water.
• Rinse thoroughly with water and dry.
Cleaning Pitcher and Personal Cup:
• Assemble unit according to diagram and instructions.
• Fill the Pitcher half full with warm water and a small amount (a couple drops)
of mild liquid soap.
• Ensure Lid and Lid Plug are securely in place.
• Press the Smoothie/Clean button.
• Let Clean cycle run completely (60 seconds)
• When nished and Blades are completely stopped, remove Pitcher Pour out
water.
• Rinse Personal Cup and Personal Cup Blade thoroughly with water and dry.
• Personal Cup Lids may be washed by hand with mild soap and sponge.
• Personal Cup Blade, Sports Lids and Personal Cup are also (top shelf)
dishwasher safe.
• Ensure all parts are clean and dry before storing at room temperature.
Cleaning Blender Base:
• Power o the Base, remove Pitcher/Personal Cup and unplug.
• Use damp cloth with mild soap to clean the Base.
• Wipe down with damp cloth and water.
• Dry completely.
• Do not oversaturate or immerse in water. This will cause damage to the unit
and possible injury to yourself and surrounding areas.
• Do not use scrubber or wire bristle brushes on any parts of the 1200W Emulsier/Blender. This can cause damage
to the unit and make it malfunction.
• Use caution when washing and drying Blades on the Pitcher and Personal Cup. They are extremely sharp and can
cause injury if not handled properly.
Storing your 1200W Emulsier/Blender:

• Ensure Blender and accessories have all been cleaned per the Cleaning
Instructions outlined.
• Blender and accessories should be stored at room temperature. They
should not be exposed to high heat or moisture.
• Keep Instruction Manual and Recipe Guide with stored Blender
• Blender is designed to conveniently t in your lower kitchen cabinet.
Warranty Information
Living Well Products, LLC warrants this product to be free of manufacturing defects. Should any such defect develop
or become evident within one year from the date of purchase, Living Well Products, LLC will replace the entire
product or, at its option, repair or replace the defective part(s) without charge. Contact Living Well Products, LLC
customer service at 888.784.2835 to determine whether it is necessary to return the unit. To return, securely pack the
entire unit. Be sure carton clearly identies sender by name and address. Attach a letter or card describing defect
and original sales receipt, along with your contact information. Mail prepaid to the address shown below.
Returns: LIVING WELL PRODUCTS, LLC, ATTN: RETURNS DEPT., 6011 Century Oaks Dr. Chattanooga, TN 37416
This warranty is void if damage or malfunction is due to abuse or failure to operate product in accordance with
instructions and on recommended electrical current. This warranty gives you specic legal rights and you may also
have other rights which vary from state to state.
Model No. MWBLND01 REV-062916 PATENT PENDING
For customer service call 888.784.2835 (+1.423.402.9010 for outside the United States) or visit us online at livingwellwithmontel.com
Pour le service a la clientele appelez le 888.784.2835 (+1.423.402.9010 a l'extérieur des États-Unis) ou visitez livingwellwithmontel.com
Para servicio al consumidor llame al 888.784.2835 (fuera de Estados Unidos marque +1.423.402.9010) o visite livingwellwithmontel.com
Read Instructions
Before Operating MADE IN
CHINA
DO NOT DISPOSE OF BATTERIES IN FIRE. ALWAYS DISPOSE OF BATTERIES PER LOCAL & FEDERAL GUIDELINES
© 2016 LIVING WELL PRODUCTS, LLC. All specications are subject to change without notice. All rights
reserved. LIVING WELL PRODUCTS, LLC. 6011 Century Oaks Dr. Chattanooga, TN 37416