Part III - Product Installation
3.1 Device Installation
(1) Check Device
Confirm whether the appearance of the equipment is good and whether the
relevant accessories are complete.
3.2 Wiring Diagram
(1) Use a multimeter to find the battery positive and negative power
leads
(2) Use a multimeter to find the ACC line, the judgment method:
The red pen of the multimeter is connected to the ACC line, and the black pen is
connected to the negative electrode. When the motorcycle key is in the OFF state,
the voltage is 0V. When the motorcycle key is turned ON, the multimeter displays
Motorcycle power supply voltage;
(2) The terminal is equipped with the red wire (positive pole) of the
power cord and the positive pole of the motorcycle battery;
(4) Insert the connector as shown above.
