LOBSTER SPORTS Elite Series Setup guide

Author: LS/RR/JJ Contributors: CT Date: 10/12/16 Revised:
Replacing and Installing a 10 Function Remote.
Repair Instructions
Step
Description
Tools
Picture
1
Models that Apply: EL02.10 (Elite two purchased with 10
function remote.), EL03.10 (Elite three purchased with 10
function remote.).
Open the control panel by unscrewing the (4) Phillips-
head screws in each corner of the control panel.
Phillips
Screw
Driver
Control Panel
2
Gently pull the control panel out, and allow it to rest
below the opening in the red case.
Control Panel Removed
3
Remove the protective strip from the adhesive side of
the Velcro strip.
Velcro Strip/ Remote
Receiver

Author: LS/RR/JJ Contributors: CT Date: 10/12/16 Revised:
Replacing and Installing a 10 Function Remote.
Repair Instructions
4
Place the remote control receiver against the left side
of the case near the center.
Press the remote control receiver firmly against the left
side of the case with the single antenna wire facing
forward and the wire connector, to the rear.
Make sure no wires became disconnected from the
board, and the antenna is not under the Velcro.
NOTE: If the antenna is under the Velcro, remote
receiver may lose its connection with the transmitter,
keeping it from working at a greater distance from the
machine.
Receiver Placement
5
Attach the wire harness connector from the remote
control receiver, to the back of the green electronic
board (PCB board) in the pins labeled “J3” or
“Remote1”.
Remote Location on Board
J3
Remote Connected
J3

Author: LS/RR/JJ Contributors: CT Date: 10/12/16 Revised:
Replacing and Installing a 10 Function Remote.
Repair Instructions
Standards
1
Make sure everything is connected properly.
2
Make sure the antenna is not under the Velcro.
3
Receiver must be on the left side of the case in the center for best results.
6
Ensure all wires are connected, and reattach the
control panel to the red case using the (4) Phillips-head
screws.
Take extra caution to feed all wires into the case and
ensure no wires are trapped between the control panel
and the red case.
Control Panel Re-attached.
7
Turn on machine.
Turn remote switch on control panel to “ON”.
Test the Feed and SWEEP functions using the
transmitter to ensure the remote receiver and
transmitter are making connection. Press or Hold down
the “elevation” button to adjust the elevation, “speed”
to adjust the speed, and “spin”to adjust the spin.
NOTE: There will be a 20 second delay from the time
the machine is turned on before the remote functions
become active.
10 Function Remote
Transmitter