LOEHR S1 CHAPTER User manual

S1CHAPTERASSEMBLY INSTRUCTIONS
1
• The mounting rail is the central
suspension point for all CHAPTER
elements.
• Align the rail horizontally at the desired
wall position and mark drilling points in
the center of the slotted holes, this allows
a horizontal shift of +/- 3mm.
• The rail itself can be used as a drilling
template, a spirit level can be placed
well on the upper surface for accurate
leveling.
• Dowels and wall screws are included.
2
• Now slide the tray over the rail from below
and secure it through the bore holes with
two screws at each side.
3
• The back panel is now slid over the side
walls of the tray with its slots facing down-
wards and then put back against the rail.
• Make sure that the side with the counter-
sunk drill holes is facing forward.

S1CHAPTERASSEMBLY INSTRUCTIONS
4
• The two screw points now connect the
back panel to the rail.
• Ensure a tight connection, the rear panel
has approx. 10mm clearance to the wall at
the top edge when correctly installed.
5
• For transportation, the divider and the
table top are shipped with connected
hinges. However, for ease of installation,
it is recommended to separately assemble
these two parts.
• The hinges can be latched and unlatched
by a mechanism. The lever to this function
is located on the hinge part, which is
attached to the table top.
• Release both hinges and disconnect the
divider and table top from each other.
CLICK!

S1CHAPTERASSEMBLY INSTRUCTIONS
6
• Now insert the divider into the tray. Two
screw points on both sides determine the
position.
7
• Secure the divider firmly with four of the
enclosed screws.

ATTENTION: The nature and strength of the wall, as well as the professional, safe
installation, are decisive for the load capacity of the desk. The specified values apply
only if these factors are given.
02-2022
[e-mail] [phone]LOEHR.CO
!
S1CHAPTERASSEMBLY INSTRUCTIONS
8
• Now the tabletop can be latched back
into the hinges.
• To do this, flip the hinges up by hand and
place the tabletop in the sockets.
• Press the hinge brackets into the sockets
by hand. An audible clicking sound can
be heard when they are correctly latched
in place.
• The table top can now be folded open
and closed.
• The hinges allow a three-dimensional
adjustment of +/- 2mm in all directions,
should a fine alignment of the table top
be necessary. Here, make sure to always
perform the adjustment on both hinges to
prevent tension.
9
• CHAPTER is now usable.
ENJOY!
CLICK!
CLICK!