LOOKING GLASS FACTORY Portrait User manual

Getting Started with
Looking Glass Portrait
Advance Beta Edition

1Attach the base plate.
• Remove the base plate oof
the back of the unit.
• Align the plate openings onto
the 2 studs - the 2 foam pads
should be facingdown.
• Slide the plate forward to lock
it in place.
2 Attach the USB-C Cable.
• Connect the included USB-C
cable to LookingGlass
Portrait’s USB-C port.
• (
I f provided) Install your
conversion head into the
provided adapter.
• Attach the USB-C cable to the
adapter and pluginto a
wall outlet.
The LED indicatorwill pulse white
toindicatethatyourunitis
readyforStandalone Mode.
3 Switch LookingGlass Portrait
ONto Standalone Mode.
• Press the ON/OFF button.
• Wait 5-8 seconds for Looking
Glass Portrait to boot up.
To switch LookingGlass Portrait
OFF, hold the ON/OFF button for 2
seconds. Onlydisconnect the
power after switchingothe unit.
Setup + ViewingHolograms
Standalone Mode

Hoo! Ray!
The included demo reel you just experienced is just the beginning.
Start makingcontent of your own byheadingto the link below:
HTTP://LOOK.GLASS/PORTRAIT-START
* Note that some software may not be available bythe time your
Advance BetaLookingGlass Portrait gets to you.
Once it is ready, we will send out aseparate note.
Forward
ON/OFF
LED Indicator
Edge Lighting
Back
Play-Pause-Loop
4 View& navigate through the included demo reel.
• When switched ON, the unit will
automaticallyloop through the
included demo reel.
• Manual Button Controls:
Forward
Back
Play-Pause-Loop
• To freeze frame ademo,
tap Play-Pause-Loop.
• To loop aparticular
demo on repeat, hold
Play-Pause-Loop for
2 seconds.
• To return to cycling
through all demos in the
reel, tap Forward or Back.
5 Adjust the edge lighting(if needed).
• Use the Edge Lightingbutton to
scroll through 4 light levels + OFF.

IMPORTANT: Whether you’re in Desktop or Standalone Mode, switch o
your LookingGlass Portrait before unpluggingfrom the power source.
You can do this byholdingthe ON/OFF button for 2 seconds.
Your PC / Mac
HDMI Display Cable
USB-C Cable
1Connect the USB-C cable to your Windows / Mac.
• (If you were in Standalone Mode) Disconnect the USB-C cable from
your power adapter.
• Connect the USB-C cable to your computer USB-C port.
2 Connect the HDMI cable.
• Connect the HDMI cable to your computer’s HDMI port.
• Connect the HDMI cable to LookingGlass Portrait’s HDMI port.
The LED indicator will pulse blue to indicate that your unit is
readyforDesktopMode.
3 Switch LookingGlass Portrait ONto Desktop Mode.
• Press the ON/OFF button.
4 Start creatingcontent.
• Go to HTTP://LOOK.GLASS/PORTRAIT-START
Setup + CreatingHolograms
Desktop Mode
© 2021. LookingGlass Factory. All Rights Reserved.
The LookingGlass Logo Design is atrademark of LookingGlass Factory(US).
LookingGlass Portrait is protected bypatents granted and pendingaround the world.
LookingGlass Portrait - GettingStarted Guide 2-01RBD13
LookingGlass Factory(US)
190 West St, Brooklyn NY, 11222 USA
www.lookingglassfactory.com