Lowell LPTR4 Series User manual

BOX 1 CONTENTS:
(1) FULL BASE ASSY &
(1) INSTALL SHEET
LPTR BASE ASSEMBLIES
LPTR19B2, LPTR19B4,
LPTR23B4 (SHOWN).
CABINET CAN BE FULLY
ASSEMBLED IN AS SHIPPED
CONDITION. SKIP STEPS 1&2
TO MOUNT BASE TO FINAL
BOX 2 CONTENTS:
(6) LPT MOUNTING RAILS
(1) VENTED PANEL
(6) CABLE LACING BARS
(10) 5/16 NUTS
(1) BAG RACK SCREWS
(1) INSTALL SHEET
(12) 10-32 X .5 SCREWS
LPTR
CABINET
BASE
SUB-ASSEMBLY
STEP 2:
REMOVE (4)
10-32 CSK SCREWS,
2X IN FRONT
2X IN BACK,
THEN LIFT OFF
CABINET
STEP 1:
REMOVE
(2) 10-32 SCREWS
TO LOOSEN TOP
SLIDING SHELF
LOCKING PANEL
INSTALL WHEN FINISNED
INSTALLING
STEP 6:
ROTATING BASE
NEEDS TO BE
FULLY EXTENDED
TO ACCESS
BASE MTG BASE
MOUNTING
HOLES
(2X) REAR
MTG RAILS
STEP 5:
CABLE LACING
BARS (3X),
MOUNTED TO
REAR RAILS
WITH 10-32 X .5
SCREWS, (6X)
STEP 4:
ATTACH REAR RAILS
TO BACK WITH
(2) 10-32 SCREWS
2 PLACES
STEP 3:
ATTACH (2X) REAR
MOUNTING RAILS
INSERT STUD THRU
HOLE ON FLANGE
AND ATTACH WITH
5/16 NUT
PUSH BUTTON
FOR ROTATING,
LOCKS(0
,60 & 90 ,
EITHER DIRECTION
UNIT WILL LOCK OUT
WHEN FULLY EXTENDED,
TO CLOSE, PRESS LEVER DOWN
AND PUSH UNIT IN.
REV
P/N: 16451
FILENAME: 16451
800.325.9660 636.257.3400 lowellmfg.com
100 Integram Drive Pacific, Missouri 63069 U.S.A.
Lowell Manufacturing Company
D
SHEET 1 OF 2
LPTR INSTALLATION

STEP 8:
CABLE LACING BARS (3X)
MOUNTED TO REAR RAILS
WITH (6) 10-32 SCREWS
STEP 7 :
ATTACH (4)
MOUNT RAILS
WITH 5-16 HEX NUTS
2X @ 4 PLACES
19.22
18.00
12.00
14.97
2.13
.254
23.230
19.125
18.00
8.00
3.37
3.37
1.89
18.00
8.00
STEP 10 :
LOCKING PANEL
ATTACHED
WITH(2) 10-32 SCREWS
STEP 9
AFTER MOUNTING
RAILS HAVE BEEN
ATTACHED TO CABINET
PLACE ON ROTATING
BASE REATTACH WITH
(4)CSK SCREWS
45.28
30.00°
18.75
.75
.49
MOUNT HOLE LOCATION
SHEET 2 OF 2
D
REV
FILENAME: 16451
800.325.9660 636.257.3400 lowellmfg.com
100 Integram Drive Pacific, Missouri 63069 U.S.A.
Lowell Manufacturing Company