LUCCI ESSE 281095 User manual

Installation Instructions
1 | P a g e v 1 . 0 ( 0 5 / 2 0 2 0 )
ESSE LED DIFFUSER
SKU# 281095
Rated Voltage 24V DC
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of this product. Please keep the instructions for future reference.
Warranty
•This appliance is covered by a 12-month warranty from the date of purchase. Please retain the proof of purchase.
•Warranty will be void if there is any damage due to improper usage or modification to the appliance.
•Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void
the
warranty.
Installation Requirements
•Select a suitable location for this appliance:
- This product is suitable for indoor use only.
- Do not place flammable material near or over the appliance. Do not place any object over the appliance, which
could prevent the airflow of the diffuser ventilation hole.
- Ensure the appliance is not installed in direct line of an air vent/system.
- If the appliance is placed in an area prone to moisture, ensure that the area is well ventilated, and an
appropriately rated exhaust fan is used if required. Damage or corrosion caused by moisture is not a product
fault, and as such is not covered under warranty.
- Keep out of the direct sunlight.
- Place the appliance sufficiently away from the power adaptor so that the power adaptor and the mains
power are not exposed to the mist and any possible water spill.
•Take care not to pull any electrical wires during unpacking as this may damage the connection.
•Lay out all the components on a smooth surface and make sure no components are missing before assembling.
If parts are missing, return the complete product to the place of purchase for inspection or replacement.
•Check whether the appliance has been damaged during transport. Do not operate/install any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
•Do not plug into the mains power socket before or during assembly. Only do so after the appliance is fully
assembled.
Installation/Operational Directions
First time to use:
1. Remove all packaging material from the product and be careful not to throw away accessories that may be hidden
within the packaging material. To help with assembly, lay the appliance on its side on a smooth non-scratch surface.
2. Select a suitable location for the appliance. Refer to the section of installation requirements.
3. Plug the connector (A) of the power adaptor onto the appliance (B). (Fig.1)
NOTE: Only use the power adaptor (C) provided with the appliance.
4. Remove the glass cover (D) from the water tank (E). (Fig.2.1)
5. Fill the clean tap water onto the water tank (E). (Fig.2.2)
NOTE: DO NOT fill the water over the ‘Max’ mark of the water tank.
6. Add the essential oil into the water tank (E) if needed. The recommended amount is 3-6 drops per each filling. (Fig.2.3)

Installation Instructions
2 | P a g e v 1 . 0 ( 0 5 / 2 0 2 0 )
7. Install the glass cover (D) back onto the water tank (E). (Fig.2.4)
NOTE: Glass cover (D) of the water tank (E) MUST BE installed before switching on the power.
8. Insert the power supply into the mains power socket outlet and ensure it is fully plugged in.
9. Turn the power on at the mains power socket.
10. Refer to the below sections for the detail operation of the diffuser and LED lighting function.
Water Refill:
1. The diffuser will stop automatically if the water tank is running out of water.
WARNING: Switch off the mains power socket outlet and unplug the power adaptor before refilling water.
2. Repeat step 4 – 9 of the last section.
Operation of the diffuser function:
1. Press the button once, and the diffuser will turn on until the water runs out in the water tank.
2. Press the button twice, and the diffuser will operate at the interval operation mode – Operates for 30 seconds
then stops for 30 seconds.
3. Press the button a third time, and the diffuser function will turn off.
4. Long press the button, and the diffuser function will turn off.
Operation of the LED lighting function:
1. Press the button once, and the LED light will enter the colour changing mode. (Colours of the LED light will
change in this sequence: White, red, yellow, green, light blue, dark blue, purple)
2. Press the button again during the colour changing mode, and the LED light will enter the manual mode. Select
7 colours in the above sequence by pressing the buttons repeatedly until the LED light turns off.
3. Press the button again to repeat step 1.
4. Long press the button, and the LED light function will turn off.
Figure 1

Installation Instructions
3 | P a g e v 1 . 0 ( 0 5 / 2 0 2 0 )
Figure 2
Troubleshooting
PROBLEM POSSIBLE CAUSE SUGGESTED SOLUTION
Both the LED lighting & diffuser
function do not work
The power adaptor is not properly
plugged in; The power is not
switched on.
Check and plug in the power adaptor to the
mains properly; Switch on the switch of the
socket outlet.
LED lighting function works;
Diffuser function is only with air
movement but no mist.
The water tank is running out of
water.
Refill the water tank according to the section
of water refill.
LED lighting function works;
Diffuser function is without air
movement & without mist.
The water level in the water tank is
over the maximum water mark.
Pour some water out of the water tank until
the water level is lower than the maximum
water mark.
Care & Cleaning
WARNING: Switch off the mains power socket outlet and unplug the power adapter before performing any
maintenance.
Regular cleaning (Every 2-3 weeks) of the water tank is required.
1. Remove the glass cover of the water tank.
2. Pour any remaining water out of the tank.
3. Use a soft damp cloth to gently wipe the inside and outside of the water tank.
NOTE: DO NOT use corrosive chemicals/solvents or abrasive cleaners, which could damage the ultrasonic
diffuser;
NOTE: DO NOT soak or immerse the product in the water or other liquids. It could damage the electronics and
create the possibility of an electrical shock.
4. Install the glass cover back onto the water tank before turning on the power.

Installation Instructions
4 | P a g e v 1 . 0 ( 0 5 / 2 0 2 0 )
Safety Warnings
•Always ensure the power is OFF and the appliance has cooled down before performing any maintenance, cleaning
and making any adjustment to the appliance.
•DO NOT switch on the power when the water tank is empty.
•DO NOT switch on the power when the glass cover is not installed.
•DO NOT try to touch the ultrasonic outlet inside the water tank. The static electric discharge of the bare hand could
damage the electronics.
•Pour out any remaining water from the water tank after use. Wipe the water tank with a clean, dry cloth.
•Use clean tap water only. DO NOT use mineral water, sparkling water which could damage the ultrasonic diffuser.
•DO NOT move the appliance when the diffuser function is operating.
•To avoid injury or damage to the appliance, ensure that power leads are secure before connecting the power.
•The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning
the use of the appliance by a person responsible for their safety.
•Young children should be supervised to ensure that they do not play with the appliance.
•In the event of the appliance being tipped or knocked over, unplug the power adaptor immediately.
•Handle the appliance and the glass cover with care to avoid any damage or breakage.
•Select a suitable location away from liquids and hazards.
•To clean, wipe with a soft damp cloth. Do NOT soak or immerse the product in water or other liquids.
•Ensure that the appliance does not come in contact with corrosive chemicals/solvents or abrasive cleaners etc.
Specifications
SKU # 281095
Colour Teak/White
Rated Voltage 24V DC, 9W
LED Specs Max.1.3W, Max.14lm, Seven colours
Max. Water volume 85ml
Diffuse capacity 20ml/hour
Diffuse duration 4 - 5 hours
Noise ≤36 dB
Applicable area 10 – 20 m
2
Weight 1.0kg
Dimensions H:150mm Dia:85mm