Lulani Maldives KA-210-31 User manual

Recommended Tools (not included)
1. Adjustable Wrench
2. Phillips Screwdriver
3. Safety Goggles
4. Flashlight
5. Bucket
6. Measuring Tape
7. Plumber’s Putty
8. Channel Locks
9. Allen Key
1
1. Faucet
2. Spray head
3. Above sink hardware: rubber O-ring
4. Below sink hardware: Quick Connector
5. Counterweight
6. Water supply lines
Parts Included
Installation Instructions
KA-210-31
Single Handle Pull-Out Kitchen Faucet
Thank you for selecting Lulani.
To ensure that your installation proceeds smoothly, please read
these instructions carefully before you begin.
Maldives
Fa u c e t C o
6
5
4
3
1
2

Caution: Tips for removal of old faucet
Always turn off the water supply before removing the existing faucet or replacing any part of the faucet.
Open the faucet handle to relieve water pressure and ensure that water is completely shut off.
Maintenance
Your new faucet is designed for years of trouble-free performance. Keep it looking new by cleaning it
periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the
finish and void your warranty.
Step 1
2
Step 2
Remove the rubber and metal washers and mounting nut
from the base by hand twisting off.
Insert the faucet through the installation hole.
Secure the faucet by firmly hand tightening the
rubber washer, metal washer and mounting nut
back on the faucet threads underneath the sink.
Tighten the screws on the mounting nut with a
Phillips screwdriver.

Step 4
3
Step 3
Assemble the quick connector (1) by inserting the clip (2)
in to place. Attach the pull-out hose (3) to the quick
connector. You will hear a light click or popping sound
when it has been securely connected.
3
1
2
Connect the water supply lines to the hot and
cold water valves. Tighten with an adjustable
wrench. Do not over tighten. Attention:
Make sure that the
inlet hoses are not
twisted.
hot supply hose cold supply hose

4
Step 5
Step 6
Congratulations! You’ve successfully finished installing your new faucet. For troubleshooting questions or
concerns, please reference the Owner’s Manual or visit our website at www.lulani.com.
We value your opinion! Don’t forget to leave us a review.
The faucet should be flushed for possible
debris prior to using. Remove the nozzle head (1)
by hand twisting off of the water supply line (2).
Turn the faucet handle all the way on, turn on the
hot and cold water supply and flush water lines for
one minute. Re-install the nozzle head by hand
twisting back on to the water supply line.
Attach the weight to the middle of the spray hose.
Use a Phillips screwdriver to secure the weight together.
Turn the water valves back on and then turn on
the faucet. Run the water flow for 15 seconds to
clean up the lines and check for any leaks.
2
1