Lumag KB3800GF User manual

- - 1 -
Owner｀s Manual
GENERATOR
KB3800GF KB3800GFE KB5000GF
KB5000GFE KB6500GF KB6500GFE

- - 2 -
KB8000GF KB8000GFE KB8000GFS
KB9000GF KB9000GFE GF9000GFS
IMPORTANT NOTICES
Please pay special attention to statements by the following words:
WARNING
A warning is used to alert the user to fact that hazardous operating and maintenance procedures may result in
injury to or death of personnel if not strictly observed.
CAUTION
A caution is used to alert the user to fact that hazardous operating and maintenance procedures may result in

- - 3 -
damage to or destruction of equipment if not strictly observed.
NOTE
A note is used to give helpful information.
This manual should be considered as a permanent part of the unit and should remain with the unit when resold.
The installation and major repair work shall be carried out only by specially trained personnel.
Contents
SAFETY 5
Safety Label Locations 5
Safety Information 6
CONTROLS 9
Engine Switch 9
Recoil Starter 9
Fuel Valve Lever 10

- - 4 -
Chock Rod 10
Ground Terminal 11
Oil Alert System 11
Circuit Breaker 12
GENERATOR USE 13
Connection to Building Electrical System 13
Ground Terminal 13
AC Applications 14
AC Operations 16
PRE-OPERATION CHECK 17
Engine Oil 17
Fuel 18
STARTING THE GENERATOR/STOPPING THE GENERATOR
20
SERVICE 20
MAINTENANCE 24
Maintenance Safety 25
Emission Control System Information 27

Maintenance Schedule 29
Engine Oil Change 30
Air Cleaner Service 31
Spark Plug Service 33
TRANSPORTING/STORAGE 36
ASSEMBLY OF PARTS 39
TROUBLESHOOTING 43
SPECIFICATIONS 45
WIRING DIAGRAM 46
OPEION EQUIPMENT 47
SAFETY
SAFETY LABELL LOCATIONS
that can cause serious injury. Read them carefully. These labels warn you of potential hazards
If a label comes off or becomes hard to read, contact your Generator dealer for a replacement.
- - 5 -

NOTICE
Never remove the WARNING label.
- - 6 -
SAFETY
INFORMATION
e safe and dependable service if operated according to instructions. Read and
understand this owner’s manual before operating your generator. You can help prevent accidents by being
SAFETY
Generators are designed to giv
familiar with your generator’s controls, and by observing safe operating procedures.

Operator Responsibility
·Know how to stop the generator quickly in case of emergency.
·Understand the use of all generator controls, output receptacles, and connections.
·Be sure that anyone who operates the generator receives proper instruction. Do not let children operate the
generator without parental supervision.
Carbon Monoxide Hazards
·Exhaust contains poisonous carbon monoxide, a colorless and odorless gas. Breathing exhaust can cause loss
of consciousness and may lead to death.
·lf you run the generator in an areas that is confined, or even partially enclosed, the air you breathe could contain
a dangerous amount of exhaust gas. To keep exhaust gas from accumulating, provide adequate ventilation.
SAFETY
Electric Shock Hazards
ugh electric power to cause a serious shock or electrocution if misused.
Using a generator or electrical appliance in wet conditions, such
·The Generator produces eno
·
as rain or snow, or near a pool or sprinkler system, or when your
- - 7 -

hands are wet, could result in electrocution. Keep the generator dry.
·If the generator is stored outdoors, unprotected from the weather, check all electrical components on the control
panel, before each use. Moisture or ice can cause a malfunction or short circuit in electrical components which
could result in electrocution.
- - 8 -
·Do not connect to a building electrical system unless an isolation switch
has been installed by a qualified electrician.
·The circuit maintenance and installation need to be gone on by
professional , and meet the following standard;
1) Article 551 of the National Electrical Code ,ANSVNFPA 70-1990,and
2) The standard for Recreational Vehicles, ANSVNFPA 501 C-1990.
SAFETY
Fire and Burn Hazards
ets hot enough to ignite some materials.
ings and other equipment during operation
·The exhaust system g
－Keep the generator at least 3 feet (1 meter) away form build
－Do not enclose the generator in any structure.

- - 9 -
rator.
The muffler becomes very hot during operation and remains hot for a while after stopping the engine .Be careful
Gasoline is extremely flammable and is explosive under certain conditions. Do not smoke or allow flames or
Fuel vapors are extremely flammable and may ignite after the engine has started. Make sure that any spilled
CONTROLS
－Keep flammable materials away form the gene
·
not to touch the muffler while it is hot. Let the engine cool before storing the generator indoors.
·
sparks where the generator is refueled or where gasoline is stored. Refuel in a well-ventilated area with the
engine stopped.
·
fuel has been wiped up before starting the generator.
ine
Engine Switch
To start and stop the eng
Switch position:
OFF: To stop the engine.

ON: To run the engine. electric start recoil start
START：To start the engine (only for electric start)
NOTICE
If the start motor has not any respond, please check the circuit break off or on.
Recoil Starter
To start the engine, pull the starter grip lightly resistance is
felt, then pull briskly.
- - 10 -
NOTICE
Do no allow the starter grip to snap back against the engine.
Return it gently to prevent damage to the starter.
CONTROLS
Fuel Valve Lever
The fuel valve is located between the fuel tank and carburetor. When the valve lever is in the ON position, fuel is
allowed to flow from the fuel tank to the carburetor. Be sure to return the fuel valve
lever to the OFF position after stopping the engine.

Choke Rod
The choke is used to provide an enriched fuel mixture when starting a cold engine. It can be opened and closed
by operating the choke lever manually. Pull the rod out toward CLOSED to enrich the mixture for cold starting.
CONTROLS
Ground Terminal
The generator ground terminal is connected to the frame of the generator, the metal non-current-carrying parts
- - 11 -

of the generator, and the ground terminals of each receptacle.
Before using the ground terminal, consult a qualified electrician, electrical inspector or local agency having
jurisdiction for local codes or ordinances that apply to the intended use of the generator.
Oil Alert System
The oil alert system is designed to prevent engine damage caused by an insufficient amount of oil in the
crankcase. Before the oil level in the crankcase can fall below a safe limit, the Oil Alert system will automatically
stop the engine (the engine switch will remain in the ON position). The Oil Alert system should not take place of
checking the oil level before each use.
If engine stops or not restart, check the engine oil level (see page 26) before troubleshooting in other areas
CONTROLS
- - 12 -
CIRCUIT BREAKER
The AC circuit breaker will automatically switch OFF if there is a short
circuit or a significant overload of the generator at the receptacle.

- - 13 -
If the AC circuit breaker is switched OFF automatically, check that
the appliance is working properly and does not exceed the rated
load capacity of the AC circuit before switching the circuit breaker
ON again.
The circuit breaker may be used to switch the generator AC power ON or OFF.
Voltage selector switch (only for dual voltage system)
The Voltage selector switch switches the main power carrying windings of the generator to produce “120V
ONLY” or “120V/240V”. If a 240V appliance is connected to the 4-prong receptacle, the switch must be in the
“120/240V” position. If only a 120V appliance is being connected to any of the120V 3-prong receptacles, select
the “120V ONLY” position.
CONTROL
Switch Position
120/240V: The 120Vand 120/240V receptacles can be used simultaneously.
120V ONLY: ONLY the 120V receptacles can be used. Do not use the 120/240V receptacle in this position.
The most power will be available at the 30A 120V locking plug receptacle.

GENERATOR
USE
Connections to Building Electrical System
Connections for standby power to a building electrical system must be made by a qualified electrician. The
- - 14 -

- - 15 -
connection must isolate the generator power from utility power, and must comply with all applicable laws and
electrical codes. A transfer switch, which isolates generator power from utility power, is available through
authorized generator dealer.
WARNING
Improper connections to a building electrical system can allow electrical current from the generator to back feed
into the utility lines. Such back feed may electrocute utility company workers or others who contact the lines
during a power outage, and the generator may explode, burn, or cause fires when utility power is restored.
Consult the utility company or a qualified electrician.
Ground Terminal
The generator ground terminal is connected to the frame of the generator, the metal non-current carrying
parts of the generator, and ground terminals of each receptacle.
Before using the ground terminal, consult a qualified electrical inspector or local agency having jurisdiction for
local codes or ordinances that apply to the intended use of the generator.
GENERATOR
USE
AC Applications

- - 16 -
Before connecting an appliance or power cord to the generator:
· Make sure that it is in good working order. Faulty appliances or power cords can create a potential for electrical
shock.
·If an appliance begins to operate abnormally, becomes sluggish or stops suddenly, turn it off immediately.
Disconnect the appliance, and determine whether the problem is the appliance, or if the rated load capacity of
the generator has been exceeded.
·Make sure that the electrical rating of the tool or appliance does not exceed that of the generator. Never exceed
the maximum power rating of the generator. Power levels between rated and maximum may be used for no more
than 30 minutes.
NOTICE
Substantial overloading will open the circuit breaker. Exceeding the time limit for maximum power operation or
slightly overloading the generator may not switch the circuit breaker OFF, but will shorten the service life of the
generator.
GENERATOR
USE

AC OPERATION
1. Start the engine (see page 16).
2. Switch ON the AC circuit breaker.
3. Plug in the appliance .
NOTICE
·Be sure that all appliances are in good working order before connecting them to the generator. If an appliance
begins to operate abnormally, becomes sluggish, or stops suddenly, turn off the engine switch immediately.
Then disconnect the appliance and examine it for signs of malfunction.
·Most motorized appliances require more that rated wattage for startup. Do not exceed the current limit specified
for any one receptacle. If an overloaded circuit causes the AC circuit breaker to switch OFF, reduce the electrical
load on the circuit, wait a few minutes and then reset the circuit breaker.
-
PRE-OPERATION
- 17 -

CHECK
ENGINE OIL
NOTICE
Engine oil is a major factor affecting engine performance and service life. Non-detergent and 2-stroke engine oils
will damage the engine and are not recommended.
- - 18 -
Check the oil level BEFORE EACH USE with the generator on a level
surface and the engine stopped.
Use 4-stroke motor oil that meets or exceeds the requirements for API
service classification SJ. Always check the API SERVICE label on
the oil container to be sure it includes the letters SJ.
SAE 10W-30 is recommended for general, all-temperature use. Other
viscosities shown in the chart may be used when the average
temperature in your area is within the indicated range.
PRE-OPERATION

CHECK
1. Remove the oil filler cap and wipe the dipstick clean.
2. Check the oil level by inserting the dipstick into the filler
neck without screwing it in.
4. If the level is low, fill to the top of the oil filler neck with the
recommended oil.
Fuel
Check the fuel gauge, and refill the tank if the fuel level is low.
Refuel carefully to avoid spilling fuel. Do not fill above the shoulder of the fuel strainer.
WARNING
Gasoline is highly flammable and explosive, and you can be burned or seriously injured when refueling.
·Stop engine and keep heat, sparks, and flame away.
·Refuel only outdoors.
·Wipe up spills immediately.
Fuel tank capacity:
25L (6.6 US gal)
- - 19 -

- - 20 -
PRE-OPERATION
CHECK
NOTICE
Fuel can damage paint and plastic. Be careful not to spill fuel when filing your fuel tank. Damage caused by
spilling fuel is not covered under warranty.
Use unleaded gasoline with a pump octane of 86 or higher.
This engine is certified to operate on unleaded gasoline.
Unleaded gasoline produces fewer engine and spark plug deposits and extends exhaust system life,
Never use stale or contaminated gasoline or oil/gasoline mixture.
Avoid getting dirt or water in the fuel tank.
Occasionally you may hear a light “Spark knock” or “pinging”(metallic rapping noise) while operating under heavy
loads. This is no cause for concern.
If spark knock or pinging occurs at a steady engine speed, under normal load, change brands of gasoline. If
spark knock or pinging persists, see an authorized to manual.
NOTICE
Running the engine with persistent spark knock or pinging is misuse, and the Distributor’s Limited Warranty dies