LuxenHome WHSL1049 User manual

Product Name:
Metal/MgO 22in. H Gray Solar Bollard Light
SKU #:
WHSL1049
Contact: [e-mail]
Instruction Manual
Please save this manual for future reference.
Thank you for purchasing this Luxen Home product. This product has been manufactured with the highest
standards of safety and quality.
Prior to use, the solar panel must be turned on.
Lift the solar panel from the top of the bollard base. On the underside of the lid, there is an On/Off switch. Move
the switch to “On”, and place panels back on each statue.
To replace the battery:
Remove the solar panel disk from the top of the bollard light. On the underside of the disk, remove screws to
replace the battery.
Battery type: AA Ni-MH 300mAh 1.2V

Product Name:
Metal/MgO 22in. H Gray Solar Bollard Light
SKU #:
WHSL1049
Contact: [e-mail]
Instruction Manual
Please save this manual for future reference.
Trouble Shooting Tips:
If your solar light does not turn on at night, it may be caused by the following:
1. Check to see if the switch is in the “OFF” position.
Resolution: Move the switch to the “ON” position and allow the solar light to be charged for at least 8
hours in direct sunlight.
2. Battery may not be fully charged.
Resolution: Make sure the solar light is placed in an area where the solar panel receives the maximum
amount of full direct sunlight every day.
3. The solar light may be located too close to other light sources (such as porch light or street lantern).
Resolution: Relocate away from external light source.
4. The rechargeable battery may need to be replaced.
Resolution: Replace with batteries of identical specification.
WARNING:
Do not dispose of batteries in the regular trash, municipal waste stream or by fire as batteries may leak or
explode. Do not open, short circuit, or mutilate batteries as injury may occur. Preserve our environment by
recycling batteries or disposing of them in accordance with Local, State, and Federal regulations.