Lynx yellobrik RYB 6000 User manual

greenMachine Quick
Reference
®
www.lynx-technik.com
RYB 6000
yellobrik extension for RFR 6000
For optimum placement and cable management within an equipment room, the
RYB 6000 rack extension allows housing of up to 6 yellobrik modules alongside
greenMachine hardware on an RFR 6000 rack frame.
RFR 6000 with greenMachine and six yellobriks in ONE RACK

2
UNPACKING THE RYB 6000 RACK FRAME EXTENSION
We have included everything that is required for assembling the RYB 6000 to the
RFR 6000 rack frame.
yellobrik rack frame extension (RYB 6000)
Warranty Card
1x rack frame extension (RYB 6000)
1x Quick Reference Guide
1x Warranty Card
WHAT‘S IN THE BOX?
Quick Reference Guide
3x Countersunk Screws

2 3
The three screw holes required for securing RYB 6000 on RFR 6000 are
shown as below:
Flip the RYB 6000 upside down as shown in the picture.
Step 1:
Step 2:
Step 3:
Step 4:
Place the RFR 6000 rack frame mounting tray over RYB 6000 and align the
holes in the mounting tray with the holes on RYB 6000.
Use the 3 countersunk screws to attach the RYB 6000 to the mounting tray.
Install RYB 6000 onto RFR 6000
1

4
Connect the primary and seconday (if needed) power supply as shown in
the picture below:
Step 1:
Connecting Power Connections
2
The chasis of RYB 6000 is equipped with two external power connectors, one for
primary power and a second for redundant power (if needed). The connectors are
located on the rear of the chassis. If supplying your own power, usa a Molex MiniFit
Series 5557 connector. Power should be 12V/10A.
Optional: Use RXT 6001 for optimum placement and management of
power supplies.
Step 2:

4 5
Partially screw one of the supplied brackets into the mounting hole (where
shown). Position the bracket to clamp the module into place and then
tighten.
Step 2:
Power Alarms
3
Any yellobrik can be mounted into the chassis and secured firmly in place with the
mechanical mounting brackets provided. Power is taken from the central power bus
which plugs into the module.
Insert yellobrik module in the rack
Step 1:
Mounting yellobrik
4
The chasis is equipped with GPIO interface that allows reporting of power
supply alarms to external interface via RJ-45 connector port. The front of the
rack consists of two LEDs that indicate power presence on each power supply
interface. In the event of a supply failure the transition to the redundant backup is
seamless.
RJ45 Pin Description
1 GPO 2A
2 GPO 2B
3 NC
4 NC
5 NC
6 NC
7 GPO 1A
8 GPO 1B
Power LEDs
GPO Power Supply State
GPO 1 Closed: Not Available
Open:Available
GPO 2 Closed: Not Available
Open:Available
GPI Interface
GPI Pinning and GPO Function

greenMachine
© LYNXTechnik AG
www.lynx-technik.com
®
DEPTH 129.5mm (5.1“)
with RFR 6000: 48.05 cm (18.92“)
WIDTH 218mm (8.58”)
HEIGHT 24mm (0.94”)
WEIGHT 480g (1.06 lbs)
MODEL # RYB 6000
EAN # 4250479325012
INCLUDES RYB 6000 rack extension and quick reference guide.
SPECIFICATIONS
Visit the
Product Page: