M-Elec ML-1009FAWI User manual

This multi-featured RGBW controller works with various remotes and controllers.
With both master and slave modes this wireless receiver saves money on running
cables. The maximum number of controllers utilising the same receiver is 8 and
RGB, RGBW and Hybrid strips can be controlled from the ML-1009FAWI.
RF Receiver
ML-1009FAWI
Colour Control RGB, RGB + White or Hybrid Strip (hybrid requires 5 channels)
Input Voltage 
Output Current 
Output Power 
Output Type 
Dimensions 
Warranty: 5 Years
TECHNICAL INFORMATION
1. 
2. 
more than 1 output, connect to 1 output and make safe all remaining outputs.
 
4. Press the learning button on the receiver
5. Select & press the zone button on the controller
 
7. 
1. 

2. 1009FAWI receiver can be controlled by up to 8 different compatible RF (radio frequency) remote devices
 
4. 
5. Hybrid strip requires a 5 channel controller but is usable with this device if only choosing 1 white colour.
MULTI COLOUR CONTROLLER
NOTES
1. 
2. 
 
4. Press the learning button on the receiver
5. Select & press the zone button on the controller
 
7. 
SINGLE COLOUR CONTROLLER
57.0

WIRING DIAGRAM
RGB/W LED strip
CCT LED strip
Single Colour LED Strip
PLEASE NOTE

• Read instructions carefully before attempting to install the fitting. Retain this guide for future reference
• IP20 please avoid the sun and rain, When installed outdoors please ensure it is mounted in a water proof enclosure
• 
• Never connect any cables while power is on and always assure correct connections to avoid short circuits before switching on
• Please ensure that the cable is secured tightly to the connector
• For latest information please visit melec.com.au
• 