Madimack AUTO R100 User manual

Installation Manual
240v Device Autor100
AUTOMATION BRIDGE

Connect 10 will need 1x unused 240V Channel (2, 3, 4, 5, 6, 7,or 8).
Temperature Sensor will need to be in the cold water side in the same line
as the heater and before the heater.
Must be fitted by a qualified person, experienced with Connect 10
controllers, as well as the heaters they are connecting to.
Is a 240v relay switch device – used to transform 240v into a low voltage
applicable communications.
1/2 metre 3pin Plug
10 metre 2 core cable
AutoR100
IMPORTANT REQUIREMENTS
INCLUDED PARTS
2

1
2
CONNECT 10 SETUP
Hardware set up:
1. Fit Connect 10 temperature sensor kit inline, before the heater.
2. Plug Temperature Sensor into "Water Temperature Plug" in Connect 10.
3. In the Connect 10 "SYSTEM/LOCAL", jumper needs to be set to "Local".
(see Connect installation for more information if not sure).
4. Plug Madimack Auto Relay male plug into empty Aux. output (usually AUX 8).
5. Run Madimack black 2 core cable from Auto Relay into Heat Pump's Control
connection 5 and 6 Terminals remove loop cable and replace with 2 core
cable. (See image below).
Note it is not polarity sensitive (can be installed either way into terminals)
6. Heat pump will show “OFF”
when connect 10 is not
sending signal for heating.
7. Set connect 10 temperature
above current temperature
and enable heating.
8. Switch heat pump ON from
controller and Set Maximum
temperature (40°C)
(The Connect 10 will control
heater).
Notes for Heat Pump
Cable from
Auto relay.
Untighten 2 screws and remove loop cable.
Screw
Loop cable
Attach two cable and re-tighten the screws.
3

CONNECT 10 SOFTWARE
Connect 10 software versions have different menus, wordings, etc. so
there may be some variations to the instructions below.
SETUP 1:
SETUP 2:
1. In the Connect 10, go to Installation Setup & Enter your PIN.
2. In Setup, under Heater, go to Is a Genus Heater installed? Select No.
3. Under "Use Connect temperature sensing?" Select Yes.
4. In the Channels setup select the Channel that will control power to this
module. (Generally Channel 8).
1. In the Connect 10, go to Installation Setup & Enter your PIN.
2. In Setup, under Heater, go to Temperature Control.
3. Select Display and control (Genus and Connect Inbuilt), then click Next.
4. Under Choose primary heater type: select your primary heater.
5. Under Choose secondary heater type: select your secondary heater,
then click Next.
6. Click through the menu and make necessary changes, and name your
heater/s.
7. In the Channels setup select the Channel that will control power to this
module. (Generally Channel 8).
FINAL CHECKING
1. Auto Relay is plugged into the assigned output Channel set above.
(usually aux 8).
2. 2 core low-voltage cable is connected to 5 & 6 terminals in heat pump.
3. Loop connector in 5 & 6 Terminal is removed.
4. Heat pump is set to max temperature.
This work must be done by a qualified, experienced person.
IMPORTANT REMINDER
3